Where is the low coolant sensor on a 2002 Buick Regal?
The sensor is easy to replace, its located on the side of the radiator. It has a metal clip that you have to remove and then you can slide off the sensor. The new sensor just pushes on. This sensor is located just below the filler neck.
Where is the low coolant sensor on a 2002 Buick Century?
Kneel below the front end of your Century and locate the radiator drain plug. Place the drain pan beneath it and pull the plug, allowing the coolant to drain to just below the sensor, which is mounted on the side of the radiator.
What to do if your Buick Regal has low coolant?
Enough of this; oil in the coolant, corroded sensor, worn out this and that, Dexcool (which is the best theory), crossing a 2000 ohm resistor over the contacts. Just unplug it and tape both the sensor receptacle and the pigtail well and check your coolant every month and look for leaks under the vehicle.
Why does my Buick Regal alarm keep going off?
If the coolant (anti-freeze) gets old and contaminated it puts a coating on the probe thus blocking the signal for the coolant level’ You can pull the probe out (a job not for the meek) and clean it or you can just live with it because even putting fresh coolant may not make the alarm go away 8 people found this helpful.
Where is coolant temp sensor on GM 3800?
Coolant Temp sensor (ECT) 9. Evap Purge Solenoid Typical engine data sensor and control component locations on the GM 3.8L 3800 v6 engine. Exact location may vary depending on vehicle year / make / model. Click on a number for a description of the component. A few related auto repair questions and answers.
What to do when your coolant sensor is replaced?
Properly dispose of used coolant. Step 16: Lower vehicle from jack stands. Place the vehicle back level to the ground. Once the coolant temperature sensor has been replaced, you need to start the engine, check for leaks, and refill the radiator fluid in most cases before you test drive the vehicle.
Enough of this; oil in the coolant, corroded sensor, worn out this and that, Dexcool (which is the best theory), crossing a 2000 ohm resistor over the contacts. Just unplug it and tape both the sensor receptacle and the pigtail well and check your coolant every month and look for leaks under the vehicle.
If the coolant (anti-freeze) gets old and contaminated it puts a coating on the probe thus blocking the signal for the coolant level’ You can pull the probe out (a job not for the meek) and clean it or you can just live with it because even putting fresh coolant may not make the alarm go away 8 people found this helpful.
Where is the temperature sensor on a 2004 Buick LeSabre?
2004 Buick Lesabre 3800 v-6. Temperature gauge needle laying down to the right past the H. Only moves,jumps a quarter of a inch when ignition is turned on. Bad temperature sensor? instrument panel cluster (gauges) problem. got had just two terminals, while the old plug has three receptacles. sensor. Some cars have 1 for the gauge or light,
Coolant Temp sensor (ECT) 9. Evap Purge Solenoid Typical engine data sensor and control component locations on the GM 3.8L 3800 v6 engine. Exact location may vary depending on vehicle year / make / model. Click on a number for a description of the component. A few related auto repair questions and answers.