How do you remove the alternator belt on a Honda Prelude?

How do you remove the alternator belt on a Honda Prelude?

Loosen the mounting nuts on the right side with a 12mm socket or wrench of the P/S pump; on is right on top of the pulley and one is underneath. Use a 10mm socket/wrench and loosen the adjustment bolt facing you. Push P/S pump down to remove tension and remove the belt. Now for the alternator.

How do you tighten the belt on an alternator?

Tighten the alternator bolts. With the serpentine or alternator belt safely seated on the alternator pulley, use the same wrench you used to loosen to the bolts to tighten them again. As you tighten the bolts, the alternator will stop tipping forward, which will increase the tension on the belt.

How often do you change the timing belt on a Honda D16?

The camshafts are rotated by the timing belt to be replaced after every 60,000 miles of mileage. You should also remember about the need to adjust valves after every 24,000 miles. A programmed fuel injection system was used in these engines. Honda D16 firing order was 1-3-4-2. The size of OEM fuel injectors was 240 cc.

How do you replace a belt on a Honda Accord?

Be sure that when replacing the old belt with a new one, you follow the same pulley sequence, which should be shown on a sticker under the hood or in your maintenance manual. If you purchased an OEM replacement belt or any other belt for that matter, the reverse side of the package may also have the diagram.

What to do if your alternator belt is squeaking?

If the visual inspection determines the belt is fine and the pulley is in good shape, best to replace the belt and ensure proper tension. Install the new belt. Tighten down adjustment bolt. See Figure 4 for the location. Ensure the new belt has no more than 8 to 10mm of deflection.

How do you change the belt on an alternator?

Look at the tensioner and insert the tool into it and apply opposing pressure to release the belt.Now, simply install the new belt making sure it fits into the grooves on all the pulleys. Start the car to check it and you are done Was this answer helpful?

The camshafts are rotated by the timing belt to be replaced after every 60,000 miles of mileage. You should also remember about the need to adjust valves after every 24,000 miles. A programmed fuel injection system was used in these engines. Honda D16 firing order was 1-3-4-2. The size of OEM fuel injectors was 240 cc.

Where does the serpentine belt go on an alternator?

If you do not have a diagram on the vehicle or in your service manual laying out the direction your serpentine belt travels through the pulleys, take a picture of it with your phone to refer to when installing the new belt. A strictly alternator belt will likely only go around an alternator pulley and the crank pulley at the bottom of the engine.

When do you change the camshaft on a Honda D16a?

The intake valve diameter was 30 mm, exhaust valves diameter was 27 mm, valve stem diameter was 6.5 mm. In 1988, camshafts were replaced with more dynamic ones, the compression ratio increased to 9.5; all this provided extra 5 HP. The camshafts are rotated by the timing belt to be replaced after every 60,000 miles of mileage.