How do I turn off anti-theft light?

Insert the car key into your car’s ignition and turn it on. The car’s accessories will be activated but not the engine. Step 3: Do another check on the anti-theft light. If it isn’t blinking any longer, then turn the key over to the Off position and let it sit for a couple of minutes.

Why does my anti-theft light stay on?

On your particular vehicle the security light staying on as the vehicle is running is an indication that the security system has failed and is disabled. It is common for a security light to come on after battery dies because the computer may lose its programming to the key.

How do I Turn Off the anti theft light in my car?

Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.

Where is the anti theft device on my car?

It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes.

Why does my anti theft light keep flashing?

Another signal is the anti-theft light flashing or the security active when starting the vehicle. This is due to the system unrecognizing your key or key signal. In some cases, it is the problem from keyless entry wiring or the system.

What should I do if my car alarm wont turn on?

If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car. Step 4: Start the engine. Attempt to start your engine. If it still won’t start, check to make sure the battery hasn’t been drained. Step 5: Repeat the process.

Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.

It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes.

If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two. This gives the system time to reset or you won’t be able to start your car. Step 4: Start the engine. Attempt to start your engine. If it still won’t start, check to make sure the battery hasn’t been drained. Step 5: Repeat the process.

How to deactivate the anti theft system on GM cars?

How to deactivate the anti-theft system on GM cars 1st WAY TO FIX IT ALL THESE STEPS MUST GET DONE USING YOUR CAR KEY. 1. lock the door 2. unlock the door 3. open it 4. shut it 5. lock the door again 6. wait about 20 seconds • This will shut the alarm off and reset the system.

How do I turn off anti theft light?

In order to deactivate the anti-theft system, car owners must press the unlock button located on the remote key. So it is suggested to use the key to unlock the door, then change the switch of ignition to “on” position.

What to do if anti theft light goes off?

Once ten minutes has passed come back and check the anti-theft light. If it has gone off, then turn the key back to the off position and remove the key. Wait for a couple of minutes to make sure that the system reset is finished. Then put the key back in and try to start the car.

How long does it take for a security light to go off?

Which one you use depends on the system and what components have been replaced. The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing. Leave the key in the On position and wait ten minutes. The flashing light should go off or illuminate without flashing.

What happens if I dont turn on my anti theft system?

The key you are using may not have the chip required to start your car. If the anti-theft system has locked up your engine, you won’t be able to start it. You’ll have to disable it with these steps. Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the “on” position.

Is it normal for the security light to go off when the engine is running?

After the learn procedure is completed and the engine is running, the security light may stay on steady for a few minutes and then go off—this is normal. Depending on the system, replacement of key components will necessitate that a relearn procedure be completed.

Once ten minutes has passed come back and check the anti-theft light. If it has gone off, then turn the key back to the off position and remove the key. Wait for a couple of minutes to make sure that the system reset is finished. Then put the key back in and try to start the car.

Which one you use depends on the system and what components have been replaced. The ten-minute procedure involves trying to start the engine. If nothing happens or the engine starts and dies, the security light will be flashing. Leave the key in the On position and wait ten minutes. The flashing light should go off or illuminate without flashing.

Why does my anti theft system not work?

My car has an automatic transmission. Your anti-theft system (pass-lock) may have a fault or it may be the key itself. The keys have a chip embedded in them. When inserted into the ignition, the alarm system looks for codes from the key. Try another key if you have one. If it starts, then the first key is bad and has to be replaced.

What should I do if my PassLock security light goes off?

If nothing happens or the engine starts and dies, the security light will be flashing. Wait ten minutes. The flashing light should go off or illuminate without flashing. When it does, turn the ignition off, wait twenty seconds, and then try to start the engine. If it starts and runs, everything is okay.