Why are the fans not running in my Pontiac?
your issue is with the temp switch not the temp sensor. the sensor will only operate the fans when it fails to avoid a possible overheating issue ,where as the switch is the fans main controller via ecm. the switch should be on the radiator itself or near the water pump. Hi, thanks for the answer.
Why is my Pontiac Grand Am GT not cooling?
It leaks coolant into the cylinders and causes inefficiency in the cooling system, leading to low coolant and overheating. You can replace this gasket with a metal one, the repair is a little involved but I managed with a Haynes manual. Good luck! My 2000 Pontiac Grand Am GT (6 cy/3.4L) has been having cooling issues.
What to do if your cooling fan relay is failing?
For this reason, if you suspect that your cooling fan, or relay, may possibly be having issues, have the vehicle diagnosed by a professional technician, such as one from YourMechanic. They will be able to look over your vehicle and replace your cooling fan relay if necessary.
Why does my AC fan not come on?
When the ac is of the radiator hoses both become same heat after a while and the overflow reservoir starts boiling over and the fan do not kick in. Any advise please. You might have an initial temperature sensor which causes the fan to come on when the temperature begins to rise; that sensor might be defective.
your issue is with the temp switch not the temp sensor. the sensor will only operate the fans when it fails to avoid a possible overheating issue ,where as the switch is the fans main controller via ecm. the switch should be on the radiator itself or near the water pump. Hi, thanks for the answer.
It leaks coolant into the cylinders and causes inefficiency in the cooling system, leading to low coolant and overheating. You can replace this gasket with a metal one, the repair is a little involved but I managed with a Haynes manual. Good luck! My 2000 Pontiac Grand Am GT (6 cy/3.4L) has been having cooling issues.
What are the symptoms of a bad cooling fan relay?
1. Engine running hot One of the first symptoms commonly associated with a bad or failing cooling fan relay is an engine that runs hot or overheats. If you notice that your engine is running at higher temperatures than normal, that may be a sign that the relay is not functioning properly.
How does the cooling fan relay work on a car?
The cooling fan relay is the relay that controls the engine’s cooling fans. When the correct parameters are met, a temperature switch or the computer will activate the relay, which will allow power to the fans. The relay will usually be activated once it is detected that the vehicle’s temperature…
Do you have an electric cooling fan in your car?
If the cooling system in your vehicle uses an electric cooling fan, most likely you have a transversal (sideways) mounted engine. However, some longitudinal (front to rear) mounted engines use the electric fan as well, but they usually have an engine-powered cooling fan.
What can be the problem with my electric cooling fan?
What could be the problem with my electric cooling fan? Answer: Usually, the problem is with the fan control module. Check for trouble codes, even if the check engine light is not on. On rare cases, the problem is traced back to the car’s computer.
Why are the cooling fans on my car not running?
The problem persists; the engine will reach 200, the thermostat opens (determined by watching the temp. gauge), but the fans do not start. If I disconnect the (new!) temperature sensor, both fans start.
How does the cooling system work on a Pontiac?
The PCM sends the signal to the BCM, which turns the fans on. Or you can buy a separate temperature fan relay system with a temp probe and bypass the system. It will work as normal cooling when needed only. Its the connecter that you unplug from the temp sensor.
Why does my heater on my Pontiac Grand Am Not turn on?
Now the heater fan runs on all speeds. So if you are having this problem of the heater fan will not turn on , in a Pontiac Grand Am or similar GM car hope this helps.If the heater fan will only run on hi it is most likely the fan motor resistor. Loading…
The PCM sends the signal to the BCM, which turns the fans on. Or you can buy a separate temperature fan relay system with a temp probe and bypass the system. It will work as normal cooling when needed only. Its the connecter that you unplug from the temp sensor.
Why does my car have a radiator fan?
You probably already know the purpose of the radiator and the cooling system in your car. When you are driving fast, the wind is passing through the radiator to cool the coolant down without issues, but when you are driving slow, there is no wind pushed through the radiator. This is why we use a radiator fan.