Where is the connector on a Cavalier radiator fan?
Inspect the fuse in the fuse relay box. Start the engine and pull the connector off the ECT. This is a two-wire connector with a yellow and a black wire. It is located near the coolant outlet on the upper rear of the hose. When the connector is pulled off of the ECT, within a second or two the fan should come on.
Where is the ECT on a Cavalier radiator?
It is located near the coolant outlet on the upper rear of the hose. When the connector is pulled off of the ECT, within a second or two the fan should come on. If it does come on, the ECT is suspect. Check the voltage with the meter by backprobing the sensor when the engine warms up.
Why is my radiator fan not coming on?
When the connector is pulled off of the ECT, within a second or two the fan should come on. If it does come on, the ECT is suspect. Check the voltage with the meter by backprobing the sensor when the engine warms up.
What is the fuse box diagram for a Chevy Cavalier?
Here you will find fuse box diagrams of Chevrolet Cavalier 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
How is the radiator fan on a Chevy Cavalier controlled?
A radiator cooling fan on a Chevy Cavalier is controlled by the computer. Its circuit goes from the battery positive to the fuse. From the fuse it travels to two relays: the low-speed and the high-speed relay.
Here you will find fuse box diagrams of Chevrolet Cavalier 1995, 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004 and 2005, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
It is located near the coolant outlet on the upper rear of the hose. When the connector is pulled off of the ECT, within a second or two the fan should come on. If it does come on, the ECT is suspect. Check the voltage with the meter by backprobing the sensor when the engine warms up.
When the connector is pulled off of the ECT, within a second or two the fan should come on. If it does come on, the ECT is suspect. Check the voltage with the meter by backprobing the sensor when the engine warms up.
Where is the relay on a radiator fan?
The fan relay is often located in the engine bay’s fuse box, but the best way is to check your repair manual to find where it is located. Testing a 4 pin relay is often very straightforward. Remove the relay and give 12 volts to pin 30 and 85. Ground pin 86 and check if there is voltage coming out from pin 87.
Where to check the blower motor relay on a Chevy?
Thankfully, it is fairly simple to tell if the relay is malfunctioning and to install a replacement. The blower motor relay is located in the under hood power distribution center and is simply labeled “Blower.” It will only take a few minutes to inspect and replace the relay if necessary. Open the hood of your Chevrolet vehicle.
Where is the blower relay on a fuse block?
Pull the blower relay out of the fuse block. The blower relay is located near the front of the fuse block and is labeled “Blower.” Inspect the center of the relay. If the metal rod inside is broken, the relay will need to be replaced.