What would make a check engine light go on?

The light could be a minor issue, such as a faulty gas cap, or it could mean something more serious, such as a misfiring engine. The check engine light — more formally known as the malfunction indicator lamp — is a signal from the car’s engine computer that something is wrong.

Can I drive with check engine light solid?

It’s okay to drive the car if the check engine light is steady. But only if the vehicle’s essential systems such as brakes and lights are operational. Keep a close eye on your car’s dashboard warning lights, including the coolant temperature and oil pressure.

How far do you have to drive with check engine light off?

30 to 100 miles
To make sure the check engine light does not reappear, it’s recommended that you drive your car 30 to 100 miles. This enables the vehicle’s “Drive Cycle” to reset, as the various sensors need time to recalibrate.

Can a dirty air filter make your check engine light come on?

A dirty air filter is one of the things that can cause your Check Engine light to come on, caused by an inadequate supply of air to the engine that results in a buildup of carbon deposits. Have your mechanic scan your vehicle to track down the source of the problem, as it could be as simple as replacing the air filter.

Is engine light an MOT failure?

Yes, your car will fail its MOT if your Engine Management Light remains on when the engine has been started. Under the new MOT rules, it is now classed as a major fault. If your light is on constantly, or it’s flashing, you should have your car checked at a garage.

What does a yellow check engine light mean?

Check your dashboard gauges and lights for indications of low oil pressure or overheating. These conditions mean you should pull over and shut off the engine as soon as you can find a safe place to do so. On some cars, a yellow check engine light means investigate the problem and a red one means stop right now.

What does the Acura check engine light mean?

Common symptoms that Acura owners notice when CEL comes on are: Check engine light flashing on and off. Check engine light, and TCS come on. Check engine light blinking. What does Acura check engine light mean? Acura check engine light (CEL) turns on to let you that the engine control unit (ECU) has detected a problem.

What is the OBD code for an Acura check engine?

P1201Cylinder 1 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0301 P1202Cylinder 2 Misfire – Compare possible causes/symptoms for this Acura check engine light code to the Generic OBD II code P0302

Why is my Check Engine light not working?

Reduced gas mileage and stalling can also indicate a MAF problem. A MAF for a late-model car typically costs between $120 and $150. An aftermarket alarm can wreak havoc on your car if it’s not installed properly. It can drain the battery, trigger the check engine light, or even prevent the vehicle from starting.

Where is the DTC code on an Acura?

1. Connect SCS service connector special tool No. 07PAZ-0010100, or equivalent, to service check connector located under the passenger’s side of dash. 2. Turn the ignition on. 3. MIL will indicate DTC’s by outputting a number of flashes. Remember, these are manufacturer specific codes only.

When to replace timing belt on Honda Acura EL?

The model years covered are 2001-2005 and apply to ALL versions of Honda’s 1.7 liter (D17 family) inline 4 cylinder engine. Procedure applies to both the VTEC or non-VTEC engines and the body style (sedan or coupe) do not change the repair procedure. Loading…