What to do if your light switch wont work?

If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic. Turn off your headlights and vehicle when you’re done.

What should I do if my dashboard light is not working?

Use a screwdriver to remove the screws holding each piece of trim in place, then pull the trim away from the dash. On some vehicles, you may have to remove the radio to access the trim. Be sure to keep track of all the screws and set them aside in a safe place so you can replace them when you’re done.

Where are the fuses for the dashboard lights?

Check under the hood, under the dashboard, or near or in the glove compartment. Once you find the fuse box or boxes, remove the lid and check the diagram on the underside of the lid for a fuse labeled “dash lights” or just “lights.” Refer to your owner’s manual if you have trouble locating the fuse boxes or the dashboard light fuse.

What should I do if my car stereo wont come out?

I’ll forward your letter the reader who originally wrote in–but I suspect the answer for them is the same. The radio will have to come out, and go to a shop that can repair it, probably by using your fix. This content is created and maintained by a third party, and imported onto this page to help users provide their email addresses.

If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic. Turn off your headlights and vehicle when you’re done.

Why are the lights on my dash not working?

Flip the switch or turn the dial or knob up and see if the lights on your dash come on or get brighter. If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb. Or, the entire switch may be faulty, in which case, have it replaced by a certified mechanic.

Why is the gear indicator not working on my Harley?

1,) The gear indicator is designed to not display with the clutch engaged while underway during normal operation. So, the ECU needs to know the clutch status in order to do this. 2.) The ignition is designed not to start while the bike is in gear and the clutch is disengaged.

What to do if your reverse lights won’t work?

Reverse lights won’t work… Be SURE fuse is good, i always check all of them but i have a tester, it only takes a few seconds! Auto or stick trans?

What should I do if my car switch is not working?

Fortunately, all 3 problems are relatively easy to fix. If the switch, fuses, and bulbs are not to blame, you likely have a wiring or electrical issue and will need to take your vehicle to a certified mechanic for diagnosis and repairs.

What happens when your dashboard lights stop working?

When the dashboard lights in your vehicle malfunction or cease to operate, the resulting effects can range from being a mere annoyance to posing a safety hazard. Locating the problem and finding a remedy is essential.