What kind of oil does a 1999 Chrysler Sebring take?
Mobil 1 Extended Performance Synthetic Motor Oil 5W-30 5 Quart.
What kind of oil does a Chrysler Sebring LXI take?
HMX™ SAE 5W-30 Synthetic Motor Oil, by Royal Purple®.
What kind of oil does my Chrysler Sebring take?
The 2004Chrysler Sebring uses SAE 5W-30 oil in the engine. Chrysler recommends that You use synthetic oil whenever You need to change it to get better wear protection.
What kind of oil does a 1998 Chrysler Sebring take?
Engine Oil
Viscosity: | 10W-30 (Above -18) 5W-30 (Below 38) SAE 5W-30 is preferred. |
---|---|
Capacity: | 4.5 quarts (with filter)After refill check oil level. |
Torque: | 29 ft/lbs (Oil Drain Plug) |
What kind of oil does a 2001 Sebring take?
Engine Oil
Viscosity: | 10W-30 (Above -18) 5W-30 (Below 38) SAE 5W-30 is preferred. |
---|---|
Capacity: | 4.5 quarts. . . (with filter)After refill check oil level. |
Torque: | 26-32 ft/lbs (Oil Drain Plug) |
What kind of oil does my 2008 Chrysler Sebring take?
Engine Oil
Viscosity: | 5W-20 (All TEMPS) |
---|---|
Capacity: | 4.5 quarts. . . (with filter)After refill check oil level. |
Torque: | 30 ft/lbs (Oil Drain Plug) |
What kind of oil does a 2010 Chrysler Sebring use?
SAE 5W-20
Chrysler Sebring 2010, SAE 5W-20 Motor Oil, by Mobil 1®.
How many quarts of oil does a Chrysler Sebring take?
5 quarts (with filter)After refill check oil level.
How much oil does a 2001 Chrysler Sebring take?
4.5 quarts
Capacity: 4.5 quarts (with filter)After refill check oil level.
How much oil does a Chrysler Sebring take?
Chrysler Sebring engine oil capacity: 4.75 liters.
How do you reset the oil light on a 2008 Chrysler Sebring?
How To Reset Chrysler Sebring Oil Change Due Light for years 2008-2010
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.
How do you reset the oil light on a 2010 Chrysler Sebring?
How To Reset Chrysler Sebring Oil Change Due Light for years 2008-2010:
- Turn the key to ON/RUN position with engine off.
- Fully depress and release the accelerator pedal 3 times within 10 seconds.
- Turn the key to the OFF position and then back on to confirm reset was accepted.