What is the speed sensor on a DTC c0050 RR?

What is the speed sensor on a DTC c0050 RR?

DTCC0050 RR Wheel Speed Circuit Malfunction Circuit Description The speed sensor used on this vehicle is a single point magnetic pickup. This sensor produces an AC signal that the EBTCM uses the frequency from to calculate the wheel speed. Conditions for Setting the DTC

What causes right front wheel speed code c0040?

Issues such as chipped reluctor teeth or a worn wheel bearing can cause code C0040. If a problem is found, the issue should be repaired and the code cleared. If nothing is discovered, check for technical service bulletins (TSBs). TSBs are recommended diagnostic and repair procedures put out by the vehicle manufacturer.

What is the diagnostic code for a c0040?

Other diagnostic codes related to C0040 C0035: Code C0035 indicates the ABS module has detected a problem with the left front wheel speed sensor. C0045: Code C0045 indicates the ABS module has detected a problem with the left rear wheel speed sensor.

What does the code c0055 on ABS mean?

C0055: Code C0055 indicates the ABS module has detected a problem with the rear wheel speed sensor circuit. C0040 is often set with sub-codes which can help with diagnosis.

What does the code c0055 mean on a car?

C0055 is for rear speed sensor, mounted on top of rear end. Unplug and remove 10mm bolt, remove. It’s a magnet, any metal shavings?

What is the code for rear wheel speed sensor?

C0055 00: Code C0055 00 indicates the ABS module has detected a short to ground, short to voltage, open/high resistance, on the rear wheel speed sensor signal circuit. C0055 5A: Code C0055 5A indicates the ABS module has detected an erratic rear wheel speed signal. No comments yet…

What does it mean when your abs says c0055?

Code C0055 indicates the ABS module has determined a problem with the rear wheel speed sensor (vehicle speed sensor) or its circuit. Get it diagnosed by a professional Code C0055 is typically caused by one of the following: Sometimes C0055 can pop up intermittently. Clear the code and see if it returns.