What is a reverse light switch?
The reverse light switch is a mechanical device used to control operation of the vehicle reverse lights. The switch is designed to complete the circuit when reverse gear is selected allowing reverse light operation (manual transmission only).
Why is my reverse light always on?
Reverse lights stay on at all times Another symptom of a failed backup light switch are reverse lights that are on at all times. If the switch shorts internally, this may cause the lights to stay on permanently.
What year did reverse lights become mandatory?
Reverse lights finally became standard equipment for the 1966 model year. From that point until the end of 1970 model year Mustangs, Shelby’s, and Cougars had separate reverse lights mounted on the rear valance.
What can cause reverse lights not to work?
On the other hand, if there is no power to the bulb terminals, there could be a faulty circuit ground, a wire break, a blown fuse (which itself would signify a circuit fault such as a short), or a bad neutral start safety switch which switch typically has the reverse light activation switch built into it.
Do side marker lights have to be Amber?
The light emitted must be amber.
Where is the reverse light switch on a car?
If the reverse light switch is attached to the transmission, you’ll have to access it underneath the vehicle. Either way, you’ll have to unscrew the old back-up light switch, disconnect the wires, connect the new one and screw it into place.
Why are my reverse lights not turning on?
Before replacing the switch, when you engaged the reverse gear, the reverse lights did not turn on, because there was a fault inside the switch itself. With the new one installed, current will be allowed to flow through the switch in the transmission, allowing the reverse lights to turn on.
How do you check a reversing light on a car?
If the lights were added after the car was made, the switch may be a manually operated one mounted on the dash. To check the reverse switch is working correctly, turn the ignition on and select reverse gear. Connect one side of the test lamp to earth and probe each terminal in turn. The switch should illuminate when each terminal is touched.
Where is the fuse box on a Cavalier?
Cigar lighter / power outlet fuses in the Chevrolet Cavalier are located in the Instrument panel fuse box (see fuses “CIG” (Cigarette Lighter) and “APO” (Accessory Power Outlet, if equipped)). The fuse box is located on the driver’s side of the instrument panel, behind the cover. It is located in the engine compartment (left-side).
Before replacing the switch, when you engaged the reverse gear, the reverse lights did not turn on, because there was a fault inside the switch itself. With the new one installed, current will be allowed to flow through the switch in the transmission, allowing the reverse lights to turn on.
Where can I get free wiring diagrams for my Chevy Cavalier?
Access our free Wiring Diagrams Repair Guide for Chevy Cavalier and Pontiac Sunfire 1995-2000 through AutoZone Rewards. These diagrams include: Access our Chevy Cavalier and Pontiac Sunfire 1995-2000 Wiring Diagrams Repair Guide by creating an account or signing into your AutoZone Rewards account.
How to repair a 1995 Sunfire Chevy Cavalier?
These diagrams include: Access our Chevy Cavalier and Pontiac Sunfire 1995-2000 Wiring Diagrams Repair Guide by creating an account or signing into your AutoZone Rewards account. Once you sign in, follow these instructions to access our Repair Guides.