What causes no power in trailer connector pk11916?

On your 2008 Chevy Silverado 2500, there could be several issues causing the plug to not have power. First, I included two pictures for reference below. In the first one, you will see the fuse box opened with a red wire going to the silver stud. This is the power that goes to a brake controller.

What should I do if my GMC power window is not working?

If there is power, then check the dark blue wires at pin B of the window switch for voltage. If no voltage is detected on any or some of the wires, the wiring in the door jamb should be wiggled while the voltage is monitored to see if the is a fluctuation. If there is, it indicates broken or loose connections in the door jamb.

Why does my Chevy Silverado have no power?

The wire all the way back to the plug seems to be good but still no power. Any suggestions would be great. Thanks. On your 2008 Chevy Silverado 2500, there could be several issues causing the plug to not have power. First, I included two pictures for reference below.

Where does the power go in a trailer connector?

This is the power that goes to a brake controller. If you look at the red wire that is below the white master cylinder in the picture, that is the wire you need for the connector to have power.

Where is the hot wire on a Chevy Silverado?

On a factory 7-Way connector the 12 volt hot wire should be the terminal at the 1 oclock position, looking at the front of the connector. If you test that terminal with a circuit tester and have no power you will want to check under the hood of your 2008 Chevrolet Silverado.

Where do you put the power wire in a trailer?

Once you have reached the battery, you need to connect the wire first to the inline fuse holder for a power converter or to the AUX post of a 40-amp circuit breaker for a 7-Way connector. If you find routing the wire up through the engine compartment too difficult, you can start at the battery and work the wire down through the engine compartment.

Where do you run the power wire in a car?

The third method of routing the power wire involves running the wire through the vehicle interior. This is usually a must if the battery is located in the trunk or cargo area or under the backseat. Every vehicle interior is different, so the path you choose to take is up to you.

Where to route a 7 way power wire?

Connect the fuse holder to the positive battery terminal before installing the fuse. For a 7-Way connector, route a separate wire from the BAT post of the circuit breaker to the positive battery terminal.