Should both front wheel bearings be replaced at the same time?

Based on this line of thinking, it would make sense to recommend replacing both wheel bearing hubs at the same time even though only one has obviously failed. As long as the other wheel bearing is not making noise and play is still within specifications, it should remain in service.

What does a wheel bearing going bad sound like?

Squealing & Growling The classic sounds of a bad wheel bearing are cyclic chirping, squealing and/or growling noise. You can also tell that the sound is related to wheel bearings if it changes in proportion to vehicle speed. The sound can get worse with every turn, or it can disappear momentarily.

How do I know if my hub assembly wheel bearing is bad?

Here is a list of signs if you have a hub assembly that may need to be replaced:

1. Snapping, clicking or popping noises when cornering or making sharp turns.
2. Grinding noise when the vehicle is moving.
3. Knocking or clunking sensation from the vehicle.
4. Wheel vibration and/or wobble.
5. Poor steering control.

How are wheel bearings removed from an Acura MDX?

The large axle nut is removed, the axle is pushed back through the center of the unitized hub assembly, and three (or more) bolts holding the hub assembly to the steering knuckle are removed. The hub assembly is then removed from the knuckle. On installation of the new hub assembly to the knuckle, the bolts are torqued to the factory specification.

How much does it cost to replace Acura wheel bearings?

Acura MDX Wheel Bearings Replacement at your home or office. Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing. Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM. Acura MDX Wheel Bearings Replacement costs $241 on average.

How do you change wheel bearings on a Toyota Tundra?

On vehicles where the wheel bearing is pressed into a cavity within the steering knuckle, the steering knuckle must be removed from the vehicle in order to press out the old bearing and press in the new bearing. On some vehicles, the wheel bearing is pressed onto an axle shaft and thus the axle must be extracted from the axle carrier.