How much oil does a 2007 Chevy Malibu hold?

How much oil does a 2007 Chevy Malibu hold?

What is the 2007 chevy malibu 2.2 oil capacity? The 2007 Chevy Malibu 2 2 oil capacity iS5 quarts. Your oil needs to be changed eventually. Every 5,000 to 10,000 miles is a good rule of thumb.

What type of oil do you put in a Chevy Malibu?

The 1.8-liter 4Cylinder takeS5 liters (5.3 quarts) of 5W-20 and the 2.0-liter 4Cylinder requireS4. 8 liters (5 quarts) of 5W-30. All fluids listed are synthetic, so they don’t require the typical 3,000-mile oil change like some people are used to.

How much oil does a 2.2 Ecotec hold?

Insert an automotive funnel in to the oil filler hole and pour in about 4.5 quarts of the engine’s 5 quart total oil capacity.

How much oil does a 2.5 L Malibu take?

Capacities

Fuel tank (gal / L): 18.5 / 70
Engine oil (qt / L): 2.5L: 5.0 / 4.7 2.0L: 6.3 / 6.0
Cooling system (qt / L): 2.5L: 7.5 / 7.1 2.0L: 7.4 / 7.0

What kind of oil does a 2007 Malibu take?

The 2007 Chevy Malibu uses SAE 5w-30 synthetic oil. The four cylinder engine requireS5 quarts, while both v6 engines require 4 quarts. Oil is important because it is a lubricant for the engine parts, it helps protect the emission system, and it can enhance fuel economy.

What type of oil goes in a 2007 Chevy Malibu?

SAE 5W-30
Engine Oil SAE 5W-30 is preferred. Capacity: 5 quarts (with filter)After refill check oil level.

Do I have to use synthetic oil in my Chevy Malibu?

How often does a Chevy Malibu need an Oil Change? Synthetic oil usually should be changed every 7,500 – 10,000 miles. An oil change is one of the most imperative and imperative services for your car. Chevy recommends getting your Chevy Malibu oil & filter changed every 3,000-5,000 miles for conventional oil.

How much oil goes in a Chevy Malibu?

To change the oil on the 4-cylinder Malibu, you need 4 quarts of 5W-30….How much oil does a 2018 Malibu take?

Engine lubricant oil capacity: 4 liter / 4.2 U.S. qt / 3.5 imp. qt
Fuel tank capacity: 49 liter / 13 U.S. gal / 10.8 imp. gal

How much oil does a 2007 Chevy Cobalt 2.2 take?

Capacity: 5.1 quarts (with filter)After refill check oil level.

How much oil does a 2.5 Ecotec take?

5 quarts
5 quarts (with filter)After refill check oil level.

What kind of oil do I need for a Chevy Malibu?

The owner’s manual of this 2006 Chevrolet Malibu specified that 4 quarts of SAE 5W-30 oil is needed for an oil change with a new oil filter. Some compatible oil filters for the GM 3500 3.5L V6 engine include the Purolator PL10111, ACDelco PF47, Mann-Filter ML 1000, Fram PH3387A and Pennzoil HPZ-9A.

What kind of engine does a Chevy Malibu have?

Owners of other General Motors vehicles equipped with the 3500 V6 engine such as the Pontiac G6, Montana, Buick Terraza, Rendezvous, Chevrolet Uplander, Impala, Monte Carlo, Saturn Relay, and Aura may also find this guide to be helpful.

Where is the oil filter on a Chevy Malibu?

The 13mm oil drain bolt is located at the rear of the engine’s oil pan facing towards the back end of the car. The engine’s oil filter is located just in front of the oil pan and behind an exhaust pipe. Since used engine oil can contain carcinogens (cancer causing agents), it’s recommended that you wear latex gloves.

What kind of oil do you put in a GM 3500?

The GM 3500 3.5L V6 engine requires 4 US Quarts of new SAE 5W-30 oil for an oil change with a new oil filter. Pour in about 3.5 quarts of oil, run the engine for a minute, allow it to rest for a few minutes, and then check the oil level on the dipstick.