How much does it cost to replace a fuel pump on a 04 Acura TSX?

The average cost for an Acura TSX fuel pump replacement is between $626 and $648. Labor costs are estimated between $83 and $105 while parts are priced at $543.

What causes electric fuel pump failure?

Fuel pump failures can be caused by electrical faults, old age (wear) or fuel contaminants (dirt, moisture or bad gas). Fuel pump failures can be caused by electrical faults, old age (wear) or fuel contaminants (dirt, moisture or bad gas). Fuel pump failures often occur without warning.

Why is my fuel pump not pumping?

These include a bad fuel pump relay or control module, a blown fuse, a wiring fault, loose or corroded wiring connector at the pump, or even an issue with the anti-theft system. These include a plugged fuel filter, pinched fuel line or a bad fuel-pressure regulator.

What can mess up a fuel pump?

Three Causes of Fuel Pump Failure

1. Fuel contamination: Fuel is jeopardized from corrosion, debris and moisture, which can all bring visible contaminants into the tank.
2. Clogged strainers/filters: The aforementioned contaminants eventually clog critical components including strainers, filters and the fuel pump itself.

Why would a brand new fuel pump not work?

If the fuel pump is not coming on, and the fuse and relay are good, then it may be possible that there is a problem with the pump or the fuel pump circuit. If it is not then there may be some sort of wiring issue before the fuel pump relay, perhaps a wiring issue or other problem with the ignition switch.

How do you clean a fuel pump without removing it?

Clean the filter with a brush without removing it.

1. Use a medium sized paint brush to remove large and small bits of debris.
2. Many internal fuel filters for these pumps cannot be removed.
3. In some vehicles, however, you can remove the filter and replace it if need be.

When did the first Acura TSX come out?

In this article, we consider the first-generation Acura TSX (CL9), produced from 2004 to 2008. Here you will find fuse box diagrams of Acura TSX 2004, 2005, 2006, 2007 and 2008, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).

When to replace fuel pump in Acura MDX?

The best course of action is to catch any fuel pump related problems early and replace the unit before it goes kaput. This article applies to the Acura MDX (2001-Present). In any modern fuel-injected vehicle, the fuel pump is responsible for supplying adequate fuel to the engine for proper operation under all conditions.

Where are the fuse panels on an Acura TSX?

Here you will find fuse box diagrams of Acura TSX 2004, 2005, 2006, 2007 and 2008, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout). Cigar lighter / power outlet fuse in the Acura TSX is the fuse №9 in the Passenger compartment.

Can a faulty fuel pump leave you stranded?

A faulty fuel pump can leave you and your car stranded in a hurry. The best course of action is to catch any fuel pump related problems early and replace the unit before it goes kaput.

Where is the fuel pump located on an Acura MDX?

The fuel pump access panel is located on the floorboard underneath the rear seats. Remove any plastic trim pieces that cover the seat mounting bolts. These are easily removed by gently prying upwards with a flat head screwdriver or small pry bar. Figure 2. Mounting bolts covers.

When do I need to replace my fuel pump?

In any modern fuel-injected vehicle, the fuel pump is responsible for supplying adequate fuel to the engine for proper operation under all conditions. Unfortunately, many consider fuel pumps to be consumable items that will require replacement at some point during the life of the vehicle.

A faulty fuel pump can leave you and your car stranded in a hurry. The best course of action is to catch any fuel pump related problems early and replace the unit before it goes kaput.

Where is the negative battery on an Acura MDX?

Locate the battery under the hood and disconnect the negative (black) battery cable. Once disconnected, some prefer to wrap the end of the cable in a towel or shop rag to prevent accidental contact with the negative battery terminal. Figure 1. Disconnect negative battery cable (yellow circle).