How much does it cost to get a timing belt installed?

Depending on your vehicle, a timing belt service could turn into a big deal and it’s going to be costly. Having a timing belt replaced before it breaks will cost between $500 and $1,000 on average while waiting for it to break before replacing can cost upward of $2,000 or more.

Is it hard to replace a timing belt?

As long as you have the right tools the Timing Belt is not that hard of a job to do, just take your time and be careful. T.L. It’s not too difficult but plan on spending a few hours on it. You’re going to have to pull the water pump off at the same time so you might as well replace it while it’s off.

Can you drive without a timing belt?

For starters, your car won’t run without a timing belt. Your timing belt rotates your car’s engine’s cam and crankshaft. If this timing is off, the engine will not run smoothly if it is even able to run at all.

Where do you place the timing belt on a timing belt?

Do not pry the timing belt onto the timing belt pulleys. Place the timing belt on each timing belt pulley and ensure proper engagement between the timing belt pulley and timing belt teeth. Lengthen the center distance or adjust the tensioning idler to remove any timing belt slack.

How do you tension a timing belt pulley?

Place the timing belt on each timing belt pulley and ensure proper engagement between the timing belt pulley and timing belt teeth. Lengthen the center distance or adjust the tensioning idler to remove any timing belt slack. Using a tape measure, measure the span length of the drive in inches. Refer to dimension “P” in the diagram above.

How to remove the timing belt from a GTE?

REMOVE TIMING BELT HINT (When re–using timing belt): Draw a direction arrow on the timing belt (in the direction of engine revo- lution), and place matchmarks on the timing belt and crankshaft timing pulley. (b) Using SST, remove the pulley. SST 09213–31021 HINT (When re–using timing belt): Remove the pulley without turning it. 21.

Can a timing belt be removed without prying?

Loosen motor mounting bolts. Move motor until existing timing belt is slack and can be removed without prying. NEVER PRY OFF A TIMING BELT, PRYING THE TIMING BELT WILL DAMAGE THE TIMING BELT PULLEYS TEETH AND/OR FLANGE THAT YOU ARE LEVERAGING AGAINST. Remove old timing belt and check the timing belt for unusual wear.

What are the benefits of replacing a timing belt?

• Increase in Horse Power. Taking your vehicle to a timing belt replacement shop and changing the timing belt as scheduled will benefit you in many ways.
• Better Fuel Economy. Changing the timing belt when needed will dramatically increase your gas mileage.
• Lower Auto Repair Cost.

  How often to you replace a timing belt?

  Unfortunately, in most cases, there are no obvious signs the timing belt is near death; it will just break. That’s why highly rated auto mechanics recommend replacing it every 60,000 to 100,000 miles. Always check your owner’s manual for the manufacturer’s recommendations.

  When to replace timing belt?

  Every car manufacturer recommends replacing the timing belt after a given time, and it is imperative to take this advice. The time or distance between timing belt replacement depends on the specific make and model of the vehicle, but on average it should be changed every 100,000 miles.

  Should I replace the timing belt?

  If your car has a timing belt, it’s important that you inspect it regularly to ensure that it’s in proper working order. This small part is critical to your engine running properly, and if it breaks the results can be catastrophic. Your timing belt should be replaced every 50,000–70,000 miles, depending on your car’s make and model.