How do you set a camshaft timing?
Timing in the Camshaft. Rotate the crankshaft clockwise to 90 degrees after TDC. This will make sure all the pistons are half way down the bore. Now position the dial gauge so that it can read the lift of the inlet valve of number 1 cylinder from the top of the valve retainer (see left).
What happens if cam timing is off?
If the timing is off, damage can occur. In some engines, called “interference engines,” the consequences can be especially bad. You could end up having to have your engine rebuilt, or even replaced. If your cam timing is off, chances are you’ll know because your car will not be running well, if it’s running at all.
How do I check my cam timing?
Begin with the intake valve; slowly turn the crank clockwise until the lifter rises 0.050 inch. Stop turning the crank and read the degree wheel. This begins duration at 0.050 inch. If our cam card says the intake valve opens at 31 degrees BTDC, the degree wheel should show 31 degrees BTDC at this time.
What are the symptoms of bad timing?
Symptoms of a Bad or Failing Timing Belt
- You Hear A Ticking Noise Coming From The Engine.
- Your Car’s Engine Won’t Turn Over.
- You Notice An Oil Leak Near The Motor.
- You Experience Exhaust Issues.
- Your Revs Start Acting Up.
How much does it cost to replace timing chain?
The average cost for a Timing Chain Tensioner Replacement is between $786 and $958 but can vary from car to car.
When should a timing chain be replaced?
The timing chain normally needs to be replaced between 80,000 and 120,000 miles unless there is a specific problem. Issues with the chain are common in higher mileage vehicles.
How do I know if my cam timing is off?
Firstly pull off the rocker cover over number 8, then turn the engine over watching the rocker gear at number 8 until you see the exhaust valve closing, then set up the dial indicator on the top of the inlet rocker directly above the push rod and on the same axis, then turn the engine over further by hand until the …
How to repair the timing chain on a Hyundai Sonata?
1. Remove the engine cover. 2. Disconnect the battery negative terminal (A). 3. Remove the air duct (B). 4. Remove the air cleaner assembly. Disconnect the breather hose (A), the intensifier hose (B) and the brake booster vacuum hose (C). Disconnect the air intake hose (D) and then remove the air cleaner assembly (E). 5. Remove the RH front wheel.
What should I do if my Hyundai Sonata stops?
Mark all wiring and hoses to avoid misconnection. In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
How do you install the ring gear on a Hyundai Sonata?
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley. Install the SST (09231-3K000) to hold the ring gear after removing the starter. Install the SST (09231-3D100) to hold the ring gear after removing the dust cover. 1.
How to fix timing chain on Kia Sportage?
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow. After tapping the SST with a plastic hammer along the direction of arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame. Do not turn over the SST abruptly without tapping.