How do you reset the timing belt on a Isuzu?

The reset is done by taking the clocks out of the dashboard. On the back there is a small silver screw, towards the middle. About 1cm away from that screw is a hole which has a silver contact going round it. Remove the screw from the hole it is in at the moment and screw it into the other hole.

How to change the timing belt on a club Isuzu?

Find the two screw holes marked KSW and move the screw from one side to the other. This will reset the light Timing belt must be replaced after 100,000 km of vehicle operation. driver to change the timing belt. 1. Remove the masking tape from the hole B. 2. Remove the screw from the hole A and install it to 3. Apply new masking tape to the hole A.

Is there any way to Reset my Isuzu Elf?

However, if the problem is present, the warning light will get back on, so resetting will not work. In this case, you need to hook the vehicle on to a scan tool, to retrieve the fault codes (as since the warning lights are on, fault codes are stored)…..

When do you change the light timing belt?

I find it easer to pop the dash pod a bit so i can get to the cable. Then unplug the wires on the dash Find the two screw holes marked KSW and move the screw from one side to the other. This will reset the light Timing belt must be replaced after 100,000 km of vehicle operation. driver to change the timing belt. 1.

When does the T Belt Light Come On?

The T-Belt light will come on just past 150 000 km, whether you replaced the belt or not. 1. Switch ignition on and select “odo” 2. Switch ignition off

Find the two screw holes marked KSW and move the screw from one side to the other. This will reset the light Timing belt must be replaced after 100,000 km of vehicle operation. driver to change the timing belt. 1. Remove the masking tape from the hole B. 2. Remove the screw from the hole A and install it to 3. Apply new masking tape to the hole A.

How to reset the belt light on an Isuzu Trooper?

Now just reset the belt light, thats even easier. After taking all the binnacle screws out, drop the steering to its lower position and take off the plastic surround. Pull the binnacle out and disconnect the multiplugs. When you take the instruments out, there is a hidden screw accessed from underneath beside the steering column on the left.

I find it easer to pop the dash pod a bit so i can get to the cable. Then unplug the wires on the dash Find the two screw holes marked KSW and move the screw from one side to the other. This will reset the light Timing belt must be replaced after 100,000 km of vehicle operation. driver to change the timing belt. 1.

How to reset a Hilux D4D T Belt Light?

Press selector and hold for 5 seconds, don’t let go 4. Switch ign. on and hold for another 10 seonds 5. Release selector, number 15 will apear 6. Press selector 15 times 7. Press and hold selector untill odo re-apears 8. Start vehicle, T-belt light is off