How do you reset the throttle body on a Dodge Ram 1500?

To reset the Dodge Ram throttle position sensor, you turn on the ignition without your foot on the brake, so the engine doesn’t start. Press the accelerator on the floor for 15 seconds. Release the accelerator, then turn the car off and start the engine and drive.

How much is a throttle body for a Dodge Ram 1500?

The average cost for a Dodge Ram 1500 throttle body replacement is between $432 and $446. Labor costs are estimated between $56 and $70 while parts are priced at $376.

How do I reset my electronic throttle control Dodge?

To reset the system all You need to do is turn on the vehicle without starting the engine. After that You can just press down on the throttle pedal for ten seconds and wait until the engine light starts to blink. When that happens it is resetting the throttle body and the ECU’s memory.

What does a throttle body spacer do?

The throttle body spacer permits more air than usual to go into the engine. Thus, the engine does not have to work as hard in order to get the correct amount of air into the combustion chamber. One of the main benefits of a throttle body spacer is an increase in horsepower.

Do you need a new throttle body unit for a Dodge Ram?

Few trucks boast the muscle and reliability that your Ram is known for. Ensure that your truck lives up to its promise by installing a new throttle body unit for Dodge Ram. When this part fails, you experience overall poor performance, including a loss of fuel economy and stalling problems.

Where can I get a new throttle unit?

This component determines how much air gets to your motor and it’s controlled by the pressure you put on your gas pedal, so shop for a quality replacement at your neighborhood AutoZone. Few trucks boast the muscle and reliability that your Ram is known for.

What’s the bore on a Dodge Ram 6.2?

Stock 5.7 hemi TB bore is 80mm and has not changed since 2003, even with the introduction of the VVT engine in ’09. On top of that, both the 6.1 and 6.4 use (d) the same 80mm TB. Only the wildly boosted 6.2’s got a factory upgrade to 92mm. Even more perspective, that monster 1000hp crate Hellephant 426? It uses the stock Hellcat/Demon TB.

How big is the throttle body on a Dodge Ram?

Yours is obviously tuned, so of course it should be a bit faster. The stock TB’s are more than large enough to feed a mildly modified engine, especially a 5.7. Stock 5.7 hemi TB bore is 80mm and has not changed since 2003, even with the introduction of the VVT engine in ’09. On top of that, both the 6.1 and 6.4 use (d) the same 80mm TB.

When to install a new throttle body unit?

Ensure that your truck lives up to its promise by installing a new throttle body unit for Dodge Ram. When this part fails, you experience overall poor performance, including a loss of fuel economy and stalling problems. Get all the parts you need for your truck by shopping online with AutoZone.

Stock 5.7 hemi TB bore is 80mm and has not changed since 2003, even with the introduction of the VVT engine in ’09. On top of that, both the 6.1 and 6.4 use (d) the same 80mm TB. Only the wildly boosted 6.2’s got a factory upgrade to 92mm. Even more perspective, that monster 1000hp crate Hellephant 426? It uses the stock Hellcat/Demon TB.

How to relearn throttle position on Dodge talk 6.7?

Click to expand… if the key is on while the pedal is disconected from the ecm on a cummins then the pedal must be recalibrated.key on,depress pedal 3 times slowly,then key off. this may not be a issue on the 6.7 due to a new type pedal. Im wired!!! Boost, you say!?