How do you reset the ABS light on a Dodge Ram?

Step 1 – Reset lights on instrument panel

1. Disconnect the negative battery terminal.
2. Put the key in the ignition and turn to “on position;” wait 30 seconds.
3. Step on the brake pedal and hold for another 30 seconds (this puts a current drain on the computer system to erase the memory).
4. Release the brake pedal.

How do you reset the ABS light on a 2003 Dodge Ram?

You can reset this light by disconnecting the battery.

1. Open the hood on your Dodge Ram and prop it up with the hood prop.
2. Loosen the nut on the clamp of the negative battery cable using the socket wrench.
3. Remove the negative battery cable from the battery terminal by sliding it up and off the battery.

How do I Turn Off the ABS light on my Dodge Ram?

Disconnect the negative battery terminal. Put the key in the ignition and turn to “on position;” wait 30 seconds. Step on the brake pedal and hold for another 30 seconds (this puts a current drain on the computer system to erase the memory). Release the brake pedal. Remove key from the ignition. Reconnect the negative battery terminal.

How to reset ABS light on Dodge Grand Caravan?

ABS has been around for as long as I can remember and is truly a boon to the car. How to reset the ABS light? Start the vehicle and put the foot on the brake. Do not remove the foot. Back the van up turning the steering wheel all the way to the right. Put the vehicle in drive while keeping the foot on the brake.

What causes the ABS light to go off without scan tool?

The following steps will help you reset the ABS light without using any scanning tool. The illuminated ABS light might be caused by the emergency brake’s failure to go down far enough to be applied. Adjust the emergency brake into the proper down position to make the light go off. Only use quality brake fluids from trusted manufacturers.

What should I do if my abs light comes on while driving?

If the ABS light turns on while you are driving, it is recommended that you first check the tires and the brake fluid level. If they turn out fine, you should consider consulting a mechanic for a scan of your module. Remember to drive and brake slowly on your way, as you cannot be sure that the car is operating at its optimum.

How do you reset ABS warning light?

Locate the DIC control panel on the dashboard in front of the driver’s seat under the speedometer. Keep pushing and releasing the “Set” button on the DIC control panel until “ABS” is shown. Hold the “Set” button for about 5 seconds to reset the light and turn it off.

How do you reset ABS control module?

Plug the computerized scan tool into it and power on the scan tool. Navigate to the “ABS” menu on the computerized scan tool by pushing the down arrow button. Select “Clear all codes.” Power off the computerized scan tool and disconnect it from the DLC connector. Turn on the vehicle and verify that the ABS module is no longer lit.

Why does the ABS light come on?

The two reasons for an ABS light to come on are to test the function of the bulb or to warn the driver that some type of fault has occurred in the anti-lock brake system. Some of the common reasons for an ABS light to come on include: Standard bulb check. Low fluid.