How do you reset a Chevy proportioning valve?

How to Reset a Brake Proportioning Valve

1. Locate the brake proportioning valve near the rear brake line. It will have one or two buttons located on it.
2. Push the reset button located on the valve with your fingers, which will reset it so the valve is working properly again. Inspect the brake pressure.

Why are my brake lights not working on my 1997 Chevy?

Pull the plastic cap off the fuse chassis and you’ll see a square relay fuse switch and replace it for the brakes. It’s only $13 bucks and is the predominant issue with 1997 Chevy Trucks and the brakes not working especially if you reverse and blinker lights do work. Was this answer helpful? Its the taillight circuit board or a broken wire.

What does it mean when your front brake is not working?

Brake Pull: Uneven braking means that you have one front brake on your Chevy that is not operating properly. Your brakes pull to the good side. This can be due to oil, grease or fluid on a pad, a caliper that is stuck, brake line blockage, or wheel bearings that are loose.

How do you know if your Chevy has a brake problem?

You will find the booster between the master cylinder and the firewall in your engine compartment. A check valve that is faulty can also let vacuum bleed out. You can diagnose this by starting your Chevy in order to build vacuum, and then turning it off for four or five minutes. Then you should try the brakes.

What causes a soft brake pedal on a Chevy?

Soft or Spongy Brake Pedal: Too much air in the system due to improper bleeding is usually the cause of this problem. However, it can also be due to fluid loss or a low fluid level. Bleed the brake lines as recommended by Chevy to fix this. You could also have a ballooning brake hose when the brakes are applied.

What to do if your rear brakes are not working?

Any electrical faults in the rear ABS system are generally indicated with a light illuminated and if so, then the flash codes can be read out. But with no light illuminated then there most likely no electrical failures in the system.

You will find the booster between the master cylinder and the firewall in your engine compartment. A check valve that is faulty can also let vacuum bleed out. You can diagnose this by starting your Chevy in order to build vacuum, and then turning it off for four or five minutes. Then you should try the brakes.

Pull the plastic cap off the fuse chassis and you’ll see a square relay fuse switch and replace it for the brakes. It’s only $13 bucks and is the predominant issue with 1997 Chevy Trucks and the brakes not working especially if you reverse and blinker lights do work. Was this answer helpful? Its the taillight circuit board or a broken wire.

What causes brake fluid to go down in a Chevy?

Even with proper maintenance, you may find yourself with an unexpected brake problem — here are some of the most common examples. Low Brake Fluid: Your Chevy may develop a leak in the system that will result in the fluid level going down.