How do you remove a fuel pump from a Chevy Cavalier?
Remove the pump lock nut with a pair of water pump pliers to free the fuel pump from the tank. If the pliers do not work, use a piece of wood or a brass punch and a rubber mallet (to prevent sparks) to strike the lock nut in a counterclockwise direction. Remove the pump by pulling it out of the tank.
Why is my Cavalier running out of gas?
If you have a full tank of gasoline and your Cavalier just stops running, you could have an issue with the fuel system. Most of the fuel system problems come from the fuel pump located in the gas tank of the Cavalier, but it can be a fuel filter as well.
Where is the fuel filter on a Cavalier?
Once the passenger rear side of the car is high enough to slide under, place the jack stand under the frame to hold the car in position. Slide under the car on the passenger rear and find the fuel filter. The fuel filter is located in the fuel line under the passenger side of the Cavalier.
How do you remove a fuel pump relay?
Remove pressure from the fuel lines. The easiest way to do this is to remove the fuel pump relay in the engine compartment fuse box. Once the relay is out, start the vehicle and let it use the rest of the fuel in the system. Disconnect the negative battery cable to prevent the system from accidentally powering and possibly igniting fuel.
How do you put a new gas pump in a car?
Bolt the new pump into place on the gas tank. Slide the tank underneath the car and position it where it should go. Reconnect the wire harness and two fuel lines.
How do you remove a fuel pump from a car?
Gently free the fuel pump from the fuel tank, being careful not to allow any debris to fall into your gas tank. Hold up the gas pump and on the end is a sock that needs to drain. Place pump out of the way. Clean the hole in the gas tank, scraping the edges to remove debris. Take the new fuel pump and place it in the hole where the old pump was.
How long does it take to replace fuel pump?
Working with fuel requires precautions. The procedure is fairly straightforward and lets you save money by doing the work yourself. With proper preparation, basic auto repair knowledge and the right tools, this job to be done in three hours or less.
Remove the pump lock nut with a pair of water pump pliers to free the fuel pump from the tank. If the pliers do not work, use a piece of wood or a brass punch and a rubber mallet (to prevent sparks) to strike the lock nut in a counterclockwise direction. Remove the pump by pulling it out of the tank.
How do you put a new fuel pump in a car?
Take the new fuel pump and place it in the hole where the old pump was. Bolt the new pump into place on the gas tank. Slide the tank underneath the car and position it where it should go. Reconnect the wire harness and two fuel lines.
Remove pressure from the fuel lines. The easiest way to do this is to remove the fuel pump relay in the engine compartment fuse box. Once the relay is out, start the vehicle and let it use the rest of the fuel in the system. Disconnect the negative battery cable to prevent the system from accidentally powering and possibly igniting fuel.
Working with fuel requires precautions. The procedure is fairly straightforward and lets you save money by doing the work yourself. With proper preparation, basic auto repair knowledge and the right tools, this job to be done in three hours or less.