How do you mount an antenna on a dish pole?
The first thing is will you be using your dish pole to mount your antenna. If so then simply detach the dish and connect the wire to your antenna. Then make sure your antenna is properly grounded with a ground wire that is run down the side of your home into the ground on a grounding rod.
How do you mount an antenna on a pickup truck?
Pickup trucks have a brake light above the cab’s rear window, which offers a convenient entry point. Simply remove the brake light and route the antenna wire through the opening. Feed it in through the bottom, and if necessary you can file a small notch in the plastic to allow for flush mounting of the brake light cover.
How can I hook up an antenna to my cable box?
First determine how the current coax cable wiring is configured. You will likely find a cable box connected to the outside of your home. Inside of this box should be either a ground block or a signal splitter . If you find a ground block you simply unscrew the cable TV feed and replace it with the antenna feed.
Can you use an existing wire for an antenna?
Having the fewest splitters and connections or cuts in the wire preserves the signal from your antenna. One good thing is you can often use your existing wire to tape a new wire to and pull it through the walls. Running wire is not that difficult but it does take time and is often best done with someone to help.
How to wire an aftermarket power antenna into the factory?
Plug in your new antenna and give it a whirl. PS – I looked at the wiring diagrams for each year 87-92 and they all appeared to have the same hookup to the original power antenna so this should be able to be applied to all years.
The first thing is will you be using your dish pole to mount your antenna. If so then simply detach the dish and connect the wire to your antenna. Then make sure your antenna is properly grounded with a ground wire that is run down the side of your home into the ground on a grounding rod.
How do you connect an antenna to a Camaro?
• Connect the Yellowwire to the battery wire. • Connect the Redwire to the accessory wire. • Connect the Pinkwire to the Pinkwire located in the HVAC harness (ignore the writing on this wire, this is NOT a “mute” wire). • Connect the Blue/Whitewire to the power antenna wire.
Is there a switch to control the antenna?
If you really want a switch to control your antenna, that’ll work just fine, but if you’re running the wire up front, why not go all the way to your stereo deck? Most aftermarket decks have an antenna control wire that lowers the antenna when the radio is off, like when you select CD/tape or turn it off.