How do you line up a crank pulley?

Put the sprocket on, with the key in place, then put the guide plate on. Then slide on your crank pulley and make sure it goes on until it bottoms out on the guide plate. It shouldn’t be bottoming out on the key. With the sprocket and key in place, make 100% sure you line up everything properly or you’ll need new valves when you’re done.

Can a crankshaft sprocket break in a Honda Odyssey?

Going slow is the key. They’ll move OK with the timing belt off but once you have to move them and the crankshaft at the same time they can break loose and then you have to stop and retorque them. yeah I will be careful with the camshaft sprocket. It’s 14 years old and I just bought this van.

Where is the Woodruff key on a pulley?

A woodruff key is installed in the hub of a pulley or gear so that the pulley or gear does not slip off the shaft it is attached to or spin freely.

How are gears and sprockets mounted on a shaft?

The various other mechanical elements like gears, cams, sprockets, etc. are mounted on the shaft at the required locations. One of the major mounting methods used for connecting such mechanical elements in place is by keys.

How does a 3 keyway crank sprocket work?

The Cloyes® Patented 3-Keyway crank sprocket allows adjustment of the crankshaft timing by ± 4°. Remember: The camshaft angle is half of the crankshaft angle, therefore the camshaft will correspondingly advance or retard by ± 2°. By changing the cam timing, enhancements to the camshaft characteristics can be achieved.

Which is the best crank pulley removal tool?

. . OEMTOOLS 37187 Harmonic Balancer Puller Kit, Works as Harmonic Balancer, Gear Pulley, Crank Shaft Pulley, & Steering Wheel Puller, Includes Bolts for GM 3300 & 3800 V6 Engines, Carrying Case, 19 piece . Only 15 left in stock – order soon.

Which is the timing mark on the crank sprocket?

The following examples illustrate which timing mark is used with its corresponding keyway: To retard the camshaft timing, use the  timing mark on the crank sprocket and the retard keyway shown above. For factory specified timing, use the Ο timing mark on the crank sprocket and the factory keyway shown above.

What’s the best way to remove a crank sprocket?

If interference is found, remove or grind that area of the block so adequate clearance is obtained. When removing a press fit crank sprocket, a proper pulling tool should be used.