How do you change the transmission on an Acura TL?

How do you change the transmission on an Acura TL?

Remove the bolt, use a funnel and refill the transmission fluid with the amount indicated in your owner’s manual. Check the cold level on the dipstick. Run the car again until the fan comes on, shift into reverse, and drive, but don’t drive the car. Shut the car down and check the dipstick for the hot level.

Where is the fill bolt on an Acura TL?

The fill bolt is just below and to the left of the fuse box. Use a 17mm socket with extension to reach the bolt. Remove the bolt, use a funnel and refill the transmission fluid with the amount indicated in your owner’s manual. Check the cold level on the dipstick.

How do you remove filter cover on Acura TL?

Use a 10mm box wrench to break free the three bolts that hold the filter cover in place. These bolts are easiest to remove by hand as well. The cover is spring-loaded, so take care when removing.

What kind of fluid does an Acura TL use?

Make sure you use the correct type of ATF fluid for the Acura TL, which used to be Honda Z1, but has since been superseded by the DW-1 fluid. The two different fluids are compatible, so no need to worry if you mix the old one with the new one. The fill bolt is just below and to the left of the fuse box.

How to change automatic transmission fluid in an Acura TL?

Acura TL 2009-2014: How to Change Automatic Transmission Fluid Step 1 – Remove the plastic undertray. Warm up the motor/transmission with a 15-minute drive, and be sure to put the… Step 2 – Loosen the ATF fill cap. Before you drain the old fluid, it is a very good idea to make sure you can get

Where is the transmission dipstick on an Acura TL?

Then, with the engine off, check the transmission dipstick again, and top off the fluid to get its level line between the marks on the dipstick. The transmission dipstick is located under the hood, conveniently at the front of the engine compartment on the driver’s side.

Can a 3rd gen Acura TL gearbox be repaired?

We have diagnostic walk throughs and repair how to’s that will keep your Acura TL 3rd Gen s gearbox humming smoothly. The bulk of Acura TL 3rd Gen s are equipped with automatic … gear boxes that require little to no maintenance. Like all things though, the transmission is susceptible to damage and can occasionally give you trouble.

Where is the drain plug on an Acura TL?

Remove this skid plate. With the plastic cover removed, you’ll find the large, bluish-colored drain plug. This may be a 17mm bolt, or it could be a recessed square hole that fits the drive from a 3/8 drive ratchet extension. Get your drain pan in place and remove this plug.

What to do if your Acura transmission fails?

And don’t ignore it, because some Honda and Acura models have had premature transmission failures in the past. One of the fixes was to equip these vehicles with two filters for the transmission.

How much does it cost to change a transmission on an Acura TL?

You should consider looking into the latest generation transmission that will fit in your car to alleviate future problems. An Acura dealership could set you back up to $4,000 or more, while an independent shop will usually be much less expensive.

Can you change ATF fluid on an Acura TL?

Changing your ATF fluid doesn’t have to be a job for the pro. If you can change your oil, you have what it takes to change the transmission fluid as well. This article applies to the Acura TL (2004-2008).

Where is the transmission plate on an Acura TL?

Underneath the front center of your car is a plastic cover that protects the bottom of the engine and provides some aerodynamics. This plate is held on by two 10mm bolts and some plastic rivets. Remove the bolts and carefully pop out the rivets by prying out the center part.

And don’t ignore it, because some Honda and Acura models have had premature transmission failures in the past. One of the fixes was to equip these vehicles with two filters for the transmission.