How do you change the timing belt on a Honda Accord?

To do this, turn the crankshaft with a socket and the ratchet attached to the threaded bolt on the front of the crankshaft. Rotate until the TDC mark on the crankshaft pulley is aligned with the pointer on the lower cover timing belt. 6) Loosen the front right wheel nuts.

How many miles should a timing belt be replaced?

The first step in timing belt replacement is selling the job. For many years, the industry standard for belt replacement was 60,000 miles. Those of us with more experience can even remember when 30,000 miles was the norm.

Where is the number one piston on a Honda Accord?

5) Place the number one piston at the top dead center (PMS), which is the highest point on the cylinder that each piston reaches as it moves up and down during crankshaft rotation. To do this, turn the crankshaft with a socket and the ratchet attached to the threaded bolt on the front of the crankshaft.

What to do when timing belt is removed on Acura V6?

With the covers removed, be sure you have number one cylinder on TDC. With the lower, outer cover removed, align the dimple on drive pulley with the mark on the oil pump (see Photo 5 ), while confirming that the cam pulley marks are in line with the marks on the inner covers (see Photos 6 and 7 ).

How often should the timing belt be replaced on a Honda Accord?

As per Honda, your timing belt needs to be serviced every 50,000 to 80,000 miles. While you’re in there, there are a few other important things to address like the timing balancer and the water pump. This article will guide you through the process of replacing the timing belt, timing balancer, and the water pump on your Accord.

Can A P / s bolt be removed from a Honda Accord?

Figure 3. P/S bolt and tensioner. The power steering pump can be removed from its bracket to gain more room. The hoses do not need to come off. The alternator as well as its related belt will need to come off in order to gain more clearance to the timing belt and water pump.

Where do you put the timing belt on a Honda V6?

With the belt in place, tighten the idler pulley bolt to 38 ft.-lbs. 13. Next, remove the retaining tool or pin from the auto-tensioner. Install the engine mount bracket to the front of engine. If you have a timing belt guide plate, install it with the concave surface facing out.

How to remove timing belt and timing balancer?

Timing tensioner. Before moving on to the next step, it’s wise to drain the coolant. Place a pan under the car, and turn the petcock on the bottom of the radiator to release. Now that the coolant has been drained and the timing belt as well as the balancer have been removed, the water pump can come out. Remove the bolts in red (Figure 12).