How do I reset my park brake?

To reset the parking brake, press and hold the foot brake. While holding the foot brake in position, move the parking brake switch to the ‘Apply’ position. If the electrical supply is disconnected from the parking brake control module, the actuator will loose its position memory.

How do you release electric park brakes?

With the AUTO switch OFF, the EPB can be applied by pushing and holding the parking brake switch. This will work with the ignition switch ON or OFF and with the vehicle moving or stationary. To release the brake, pull and hold the manual switch while at the same time pressing the brake pedal.

Why does my handbrake light stay on?

Faulty Switch: One common reason for the Parking Brake light to stay on is a failing or failed switch. This can be checked easily by moving the handle to and fro after it is down. If the light turns off (or turns off and then back on), the switch is the most likely culprit and will need to be replaced.

How do I reset my brake warning light?

How to Reset a Brake Warning Light

1. Find your vehicle’s Assembly Line Diagnostic Link port.
2. Attach an OBD1 or 2 scanner to this port and turn the key in the ignition but do not start the engine.
3. Press “OK” and read the code.
4. Service the brakes according to the problem diagnosed by the code.

Can electric hand brakes fail?

Yes. Its just like the regular brakes except there is only 1 or 2 and much smaller since it don’t have to stop The car. The electronic part is just a small motor that moves the pads in or out. The motor can fail.

What happens when the parking brake does not release?

Parking brakes can be mind boggling when it does not release. When the parking brake does not release, you can damage the transmission or engine trying to overcome the braking force. The parking brake system is simple in design and helps keep the vehicle from moving when placed at rest.

Where do I find the parking brake settings?

The specific Basic Setting groups vary depending on the vehicle and repair procedure to be performed. Using VCDS you will click [Select] > [53 – Parking Brake] > [Basic Settings – 04] and TYPE in the specific Group Number -or- Select the appropriate option from the drop-down menu.

Do you need an electronic parking brake reset?

Have a look around the S type sub forum here, same set up. You will need a piston windback tool. Have a look around the S type sub forum here, same set up. You will need a piston windback tool. Click to expand… Yes thanks I have read a lot about it, well all I could find anyway.

How long does it take to release parking brake pistons?

Now it is time to release the parking brake pistons. You can either do this with a diagnostic scanner or a special tool for your parking brake. You should hear the pistons are going back for 2-3 seconds if everything is done right.

What to do if your parking brake won’t release?

Step 1: Put on your safety glasses and grab your flashlight Locate the parking brake cable in the cab of the vehicle. Step 2: Check to see if the cable is corroded or full of rust. Look for the cable pin to be corroded to the parking brake pedal. Step 4: Look at the connections.

Is the parking brake automatic on the A6 C6?

For some reason, probably having to do with the legal department, American and Canadian versions of the A6 C6 with the electronic parking brake lack the automatic release they get in Europe and Asia.

How do you change the parking brake setting?

When you press the gas, the parking brake should automatically disengage. Figure 2. Navigate to option 53-Parking Brake. Figure 3. Change the parking brake setting from USA/Canada to ROM. The electronic parking brake auto release hack will only release when the transmission is in drive. It will not release if the transmission is in park.

How can I tell if my car has a parking brake?

You can test it out and make sure everything is working correctly by placing the transmission in drive, then setting the parking brake. When you press the gas, the parking brake should automatically disengage. Figure 2. Navigate to option 53-Parking Brake.