How do I program my 2008 Silverado key?

2008 Chevrolet Silverado 1500 Key Programming

1. Insert the original, already programmed key in the ignition and start the engine.
2. After the engine has started, turn the key to off and remove the key.
3. Insert the key to be programmed and turn it to on within 10 seconds of removing the original key.

How to program a Chevy Silverado keyless entry remote?

Press and hold lock and unlock buttons on first remote simultaneously for 15 seconds. Wait for sound signal indicates correct programming. Repeat above procedure to program remaining remotes. Switch ignition OFF to exit programming mode. Remotes can also be programmed using diagnostic equipment. A maximum of 8 remotes can be programmed. Loading…

Do you need a fob for a Chevy Silverado?

A keyless entry remotes makes our lives easier by locking and unlocking the Silverado from up to 40 feet away. If you’ve purchased an additional remote, also known as a fob, you’ll need to program it to sync with your truck.

How do I Reset my Chevy Silverado remote?

Start your Silverado and leave it in Park. Step 2: Press and hold the Vehicle Information button, marked by an image of a car and the letter “i”, until the display reads “Press V to Relearn Remote Key”. Step 3: Press the Set/Reset button until “Remote Key Learning Active” appears.

How do you lock and unlock a Chevy Silverado?

Your Silverado will automatically cycle the locks as it did in Step 2. Step 5: Simultaneously hold down the Lock and Unlock buttons on your fob for 15 seconds. Step 6: Program any additional remotes for repeating Step 6 for each remote. Up to four remotes can be programmed. Step 7: Exit programming mode by starting your Silverado.

How can I program keyless entry remote?

Programming a Key Fob Turn the ignition on. Sit in the driver’s seat with the ignition key and the key fob (also called a keyless entry remote). Press the lock button on your remote. Aim the remote at the transmission receiver if you know where it is. Turn the ignition off. Immediately reach for the key in the ignition.

Can “I” program my keyless remote?

Many keyless entry remote fob and smart key programming procedures allow you to do the programming yourself for free. However, some vehicles will require an Automotive Locksmith with special equipment.

How do you program a GM keyless remote?

Hold down the “lock” and “unlock” button on the keyless remote to program it to the vehicle. Wait for the doors to lock and unlock again to signal that the programming is complete. Repeat the procedure to program a total of four remotes to your GM vehicle.

What is remote keyless system?

The term remote keyless system (RKS), also called keyless entry or remote central locking, refers to a lock that uses an electronic remote control as a key which is activated by a handheld device or automatically by proximity. Widely used in automobiles, an RKS performs the functions of a standard car key without…