How do I fix code p1166?

Some of the most common repairs are:

1. Repair short in the wire between A/F sensor relay and fuses.
2. Repair open in the wire between the PCM and the A/F sensor 1 or Secondary HO2S sensor 2.
3. Replace front O2 sensor.
4. Replace faulty PCM.

How do I fix code p1167?

Replacing the Rear Oxygen Sensor usually solves the problem. If it doesn’t, then other possible repairs include: Repair or replacement of A/F sensor or relay. Repair or replace bad wiring….How to Fix

1. Electrical harness and connectors.
2. High pressure pump.
3. Diesel fuel high pressure connector.
4. Engine PCM.

Where is the knock sensor located on a 2002 Honda CRV?

The 2002 Honda CR-V 2.4 knock sensor is mounted under the rear of the exhaust manifold on the right cylinder head. Weak fuel economy, loss of acceleration strength, You hear engine knock or ping and Your engine light is on are some of the typical signs of a defective knock sensor.

Is a 2002 Honda CRV AWD?

The Used 2002 Honda CR-V comes with all wheel drive, and front wheel drive. Available transmissions include: 4-speed automatic.

What does the code P0141 mean?

oxygen sensor’s heater circuit
Code P0141 occurs when the powertrain control module tests the downstream heated oxygen sensor’s heater circuit on Bank 1 and detects a short in the circuit or excessive resistance in the heater circuit.

What does a knock sensor do on a Honda CRV?

The Engine Control Unit uses this signal to modify engine operating parameters, typically spark timing and sometimes air fuel ratio, in an effort to stop the detonation. The knock sensor detects engine knock which can eventually destroy an engine.

Are 2002 Honda CRV good cars?

The Honda CR-V’s redesign yielded big improvements. The four-cylinder engine is smooth and spirited yet economical. The interior is roomier, and fit and finish are very good. The CR-V is among the top-scoring small SUVs and represents a good dollar value.