How can I by pass the anti theft system on my car?

Cut the yellow wire and the orange/black wire or on some vehicles, it is the yellow and black wires. Solder the resistor between those wires. Tape it up and put the covers back on and follow this relearn procedure. If this does not work you have a wiring problem in the steering column. 1. Turn on the ignition, with the engine off. 2.

How to bypass factory theft on a GM vehicle?

This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle. You can get this kit from New Rockies.com . I came across this site surfing the net when I was having a similar issue on a GM vehicle.

Is there a way to bypass the factory security system?

If you don’t want to bypass the factory security system but rather fix it the right way, click here to speak with a mechanic. Here is a list of GM vehicles that have VATS, Passkey or Passlock security system built in from the factory.

How to bypass vats, Passkey and PassLock security systems in GM?

It can be VATS, Passkey or Passlock anti theft system that is going bad causing your issue. I am going to share a secrete with you on how you can bypass these systems with very little effort. This is a really unique security system bypass kit that you can use to override your current factory theft system on your GM vehicle.

Is there a way to bypass the pass lock sensor?

The most common failure is the pass-lock sensor itself and I can give you a way to bypass that but the rest of the system must remain operational. Go buy a 2.2k (2200 ohm) ohm resistor at an electronics store. Go to radio shack and just get one as close to that as you can.

How do you shut down a 791 transponder bypass?

NOTE: If you are using the 791 Module as a transponder bypass you must insert a spare ignition key inside the plastic ribbon coil (as illustrated on page 3) then snap both halves of the module back together. This FUEL SYSTEM shutdown anti-theft system is based on a pellet (resistor) built into the steel shaft of the ignition key.

When do you turn off the PassLock system?

The vehicle learns the Passlock Sensor Data Code and/or resistance on the next ignition switch transition from OFF to CRANK. You must turn the ignition OFF before attempting to start the vehicle. 12. Your all done, Solder all your new connections.