Does the intake valve open after TDC?

Intake stroke. The piston is now at TDC, both the intake and exhaust valves are partially open. As the piston travels back down the cylinder, the exhaust valve goes fully shut and the intake valve goes fully open and starts to shut. Compression stroke.

When is the bottom end of a piston at TDC?

There is no concept of a compression stroke if you remove the cam from the equation. The bottom end simply goes up and down. When piston number 1 is at the top of it’s travel, your bottom end is at TDC.

Where to find alignment mark on camshaft sprocket?

The camshaft sprocket alignment mark is visible through the opening in the front distributor housing cover just above the distributor cap. When the letters “OT” are visible in the window, continue to rotate the engine clockwise until the scribe mark (line) beside the “OT” is aligned with the tab inside the window.

What’s the difference between the cam and the intake?

It makes no difference how you degree the cam in the engine, the lobe separation angle is ground into the cam. The intake centerline, on the other hand, is the position of the centerline, or peak lift point, of the intake lobe in relation to top dead center of the piston. This can be changed by “degreeing” the cam into the engine.

Where does the crankshaft go when setting to TDC?

So, if you simply set the crankshaft to TDC without looking at the position of the camshaft, you may actually be at TDC on the exhaust stroke for cylinder #1.

It makes no difference how you degree the cam in the engine, the lobe separation angle is ground into the cam. The intake centerline, on the other hand, is the position of the centerline, or peak lift point, of the intake lobe in relation to top dead center of the piston. This can be changed by “degreeing” the cam into the engine.

How to find the piston Stop gauge ( TDC )?

Piston Stop Gauge A more accurate way to locate (TDC) is by using a piston stop tool. Screw the tool into the #1 spark plug hole by hand; and then slowly rotate the crankshaft by hand until the piston come up against the stop.

Where does the piston go in a compression stroke?

The piston again goes all the way to the bottom and as it starts up, the intake valve is rushing towards the seat. The closing point of the intake valve will determine where the cylinder actually begins to build pressure, as we are now into the compression stroke (figure 4).

Where to find the top dead center on a compression stroke?

As a general reference point, or when installing a distributor, Top Dead Center (TDC) on the compression stroke is required. Usually it can be found by looking at timing marks; but on some engines these marks may be lost or hidden.