Can you replace a shift solenoid yourself?

Replacing a transmission shift solenoid can be done by most any auto repair shop, automobile dealership service center or you can do-it-yourself “DIY”.

How much does it cost to fix a shift solenoid?

Depending on the make, model, and year of your vehicle, you should expect to pay between $15 and $100 for a single transmission shift solenoid replacement cost. A pack of the transmission solenoid replacement can be between $50 to $300.

How do you unstick a shift solenoid?

What Repairs Will Fix P0752?

1. Changing the transmission fluid and filter.
2. Replace faulty solenoid.
3. Repair or replace a faulty transmission pump.
4. Repair or replace defective transmission valve body.
5. Perform transmission flush to clean passages.
6. Cleaning corrosion from connectors.
7. Repairing or replacing wiring.

Can I drive with a bad shift solenoid?

Can You Drive It? The short answer is that, yes, you can usually drive a car with a bad shift solenoid. Granted, it might not shift past a particular gear, but you should be able to drive it for a short period of time without causing any serious damage.

Why are the solenoids on my Acura not working?

Multiple solenoids are mounted on the valve body of the Acura transmission. Due to age, these solenoids can fail or get sticky, causing erratic shifting. Sensors mounted on the valve body can get dirty or stop working if there is a short in the wire harness. It is possible to overhaul the valve body instead of replacing it.

What to do if your Acura shifter won’t move?

Valve body repair kits are available and less expensive than replacing the whole valve body. It can be scary if your Acura shifter won’t move out of Park. Not only are you stuck in a parking lot or garage, but now you are worried about an expensive car repair.

What should I do if I have a transmission problem in my Acura?

Certain Acura transmission problems can be fixed by updating the transmission software, while other issues may require complete transmission replacement. If your Acura is still under factory warranty, we recommend taking your vehicle to your nearest Acura dealer.

How long does it take to change transmission fluid in Acura?

Drive your Acura around for at least 15 minutes. Make sure to shift the transmission between all the gears if necessary manually. This will allow your Acura transmission fluid to reach operating temperature. Remove the transmission dipstick and determine the fluid level.

What happens when solenoid fails on Acura TSX?

When the solenoid fails, the transmission may seem to be “stuck” in 2nd or 3rd gear and not upshift, or be recalcitrant with downshifting to a lower gear. These solenoids can fail and they will cause diagnostic trouble codes to appear on your dash. Use a OBD-II trouble code reader and retrieve any error codes stored in the car’s computer.

What kind of transmission does an Acura TSX have?

This only applies to the automatic transmission, as the manual transmission is mechanical, and does not have the same reliance on electrical controllers like the auto. That said, the most common electrical-related issues with the TSX’s automatic transmission are related to shift solenoids.

Where is the shifter reset button on an Acura TSX?

Try toggling the shift lock pin: Look just below your shifter on the plastic trim panel that surrounds the shifter. Look for the small tab or indent. Flip that up and toggle the button underneath. That is the shift lock-out/reset toggle. See if the issue is resolved. Figure 3. Shifter reset tab on Gen 2 TSX.

What does slipping mean in an Acura TSX?

Slipping refers to the engine RPMs shooting up, and the car not accelerating. This happens in a few instances: A damaged torque converter in your automatic transmission. If it’s not the torque converter, your transmission may have an internal defect or damage.