Can I pass smog with EVAP not ready California?

AN incomplete evaporative monitor will not cause a smog check failure. It will be the only monitor allowed to be incomplete on a 2000 & newer vehicle.

What is a drive cycle for smog check?

An OBD monitor is a computer test or series of computer tests used to determine if an emission control device or system is failing. The vehicle performs the self-diagnostic computer test when the vehicle is driven. This is commonly referred to as a “drive cycle.”

How long do I have to drive my car to reset the computer?

The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.

When to do a smog check on a Honda Acura?

If the MIL turn off again, then the readiness monitors are set. If they blinks five times, the readiness monitors are not set and you need to conduct the Honda Acura Drive Cycle for smog check readiness. (Note: At A Star Smog, we will use an OBDII scanner to conduct a smog precheck).

What’s the best way to do a smog test?

Start the motor and keep the car idle for 20 seconds. Don’t touch the accelerator. Rev the engine to 2000 RPM for 3 minutes. The temperature should be at 1/3 of the scale or higher. Idle for 20 seconds again. Go to a highway and drive between 50-60mph for 20 minutes.

What should the air temperature be in a Honda Acura?

Ensure the air temperature is approximately 40° and 95°F. Start the motor and keep the car idle for 20 seconds. Don’t touch the accelerator. Rev the engine to 2000 RPM for 3 minutes. The temperature should be at 1/3 of the scale or higher. Idle for 20 seconds again.