Can AutoZone check your starter and alternator?
Every AutoZone in the USA will check your alternator, starter, or battery at no charge.
Can AutoZone test alternator on vehicle?
If you think your vehicle’s alternator or battery may be suspect, you can seek out one of our preferred shops in your area to help. This test may not pinpoint whether the alternator is bad or not, but you can also remove the alternator from your vehicle and have it tested at the nearest AutoZone auto parts store.
How accurate is AutoZone alternator test?
Before heading to the repair shop, I stopped by AutoZone on my way home. In 5 minutes, they hooked up their equipment and tested the battery load. They advised the alternator was toast – confirmed that with the repair shop the next day. Short answer – Yes, they’re accurate.
Why does AutoZone test the alternator and charging system?
Keep in mind, when you test your charging system while the car is running, or AutoZone does the same, the system voltage is being tested at the battery, and if it’s not getting a charge, the test cannot determine why. Either the alternator itself is at fault, or the wiring between it and the battery are.
What causes a car starter to not turn over?
However, when powered, it should send a signal to the starter relay once the key is turned or the starter button is pressed. If you press this button or if you turn the key on a manual ignition switch and the vehicle does not turn over, it may be caused by a problem with the starter relay.
What are the symptoms of a bad starter relay?
Listed below are a few of the symptoms of a damaged or worn out starter relay. If you notice these warning signs, make sure you contact a local ASE certified mechanic to completely inspect your vehicle as these symptoms might indicate problems with other components. 1. Vehicle does not start
What does it mean when your alternator is not charging?
If the voltage is still only 12.4-12.6 once the engine is running, then the charging system is not functioning. In most cases and in most vehicles, you will have a battery light illuminated that indicates that the alternator is not charging.
Keep in mind, when you test your charging system while the car is running, or AutoZone does the same, the system voltage is being tested at the battery, and if it’s not getting a charge, the test cannot determine why. Either the alternator itself is at fault, or the wiring between it and the battery are.
Why does my car not start with a new battery and alternator?
With a new starter, battery, and alternator (assuming you have not drained the battery attempting to start it), the starter should attempt to crank over the engine. If the starter does not make any noise when the key it turned to crank over the engine, you have an issue with the fuses, or the circuit.
What should I do if my alternator is not working?
The first course of action is to check the wiring carefully that runs between the alternator’s main power wire and the battery. A worn, loose, or damaged connector can cause a massive voltage drop. If everything appears fine, the alternator should be removed and bench tested, which can be done for free at AutoZone.
How does the charging system work on an alternator?
The charging system is composed of wiring that not only supplies the battery and system with DC power, it also “senses” the voltage that’s out in the system in order to properly set the voltage leaving the alternator.