Can a Mercedes C class door lock be replaced?

If the door locks in your C-Class are bouncing up and down or are otherwise not functioning properly, the system’s actuator might be broken. This is a costly component to replace at the repair shop, but it is something you can do at home. Read on to learn how to replace it yourself.

How do you remove the door handle on a Mercedes C class?

Once done, remove the handle’s blanking plate and unscrew the T20 Torx that holds the outer door handle. Now, in order to remove the handle, first remove small part of the handle release by removing the previous T20 Torx. Next, slide handle to the left to release from vehicle.

How to replace the actuator on a Mercedes C class?

Attach wires to new actuator and slide into housing area. Re-install the bearing clamp, and slide the two foam blocks back into place. Re-install the T20 Torx screws and the door handle. Re-install the T30 Torx screws, and slide door trim back into place. Finally, re-install the T20 Torx screws as you slide the lock cover back into place. Help!

How do you remove a lock mechanism from a door?

Now, remove the two Torx bolts under the handle cover. Figure 1. Lock mechanism mounting screws. Carefully lever around the edge of the door trim, and lift it off. Pull up and forwards on the door trim to remove. Disconnect all hook linkage, and remove insulation in order to access actuator housing area.

If the door locks in your C-Class are bouncing up and down or are otherwise not functioning properly, the system’s actuator might be broken. This is a costly component to replace at the repair shop, but it is something you can do at home. Read on to learn how to replace it yourself.

How to remove the rear door panel on a Mercedes Benz?

Rear door panel removal Mercedes Benz C Class w204 – YouTube here is how to remove the rear door panel from a mercedes benz C Class w204 from 2012 Here is what removal tools i use :https://amzn.to/2LPmZxNWith this c…

Can a door actuator be removed from a Mercedes?

However, removing that actuator can be very difficult depending of the door’s design . So in this video I will show you how I did remove the door panel , remove the door actuator and repair the door lock actuator on a Mercedes w203 c class This process can be similiar on any Mercedes manufactured between 1998 and 2006 .

How do you remove a door lock actuator?

Carefully lever around the edge of the door trim, and lift it off. Pull up and forwards on the door trim to remove. Disconnect all hook linkage, and remove insulation in order to access actuator housing area. (Related Article: How to Remove Door Trim Panel – MBWorld.org) Remove the T30 Torx screws holding the actuator.

Rear door panel removal Mercedes Benz C Class w204 – YouTube here is how to remove the rear door panel from a mercedes benz C Class w204 from 2012 Here is what removal tools i use :https://amzn.to/2LPmZxNWith this c…

However, removing that actuator can be very difficult depending of the door’s design . So in this video I will show you how I did remove the door panel , remove the door actuator and repair the door lock actuator on a Mercedes w203 c class This process can be similiar on any Mercedes manufactured between 1998 and 2006 .

Where is the fuse on a Mercedes-Benz W203?

Twist screws (1) 90° counterclockwise. Slide-out retainer (3) and remove the cover by pulling towards the front. Install cover (2) in reverse order. It is on the left-hand side of the trunk. Japan version: VICS+ETC voltage supply separation point.

What should I do if my Mercedes fuse blows?

If a newly inserted fuse also blows, have the cause traced and rectified at a qualified specialist workshop, e.g. an authorized Mercedes-Benz Center. Before changing a fuse, secure the vehicle against rolling away and switch off all electrical consumers. Always disconnect the battery before servicing high current fuses.

Why does my Mercedes-Benz W204 rear door not unlock?

I have a 2007 W204 and the passenger rear door behaved in the same way. Mine eventually wouldn’t unlock at all. Door panel has to be removed and part of the lock replaced. This is a known fault, according to my dealer at the time they had replaced quite a few mechanisms!

Can a Mercedes Benz lock itself when you walk away?

This thread is proof that money can buy a Mercedes but not brains or class. Seriously though, no modern car locks itself when you walk away as far as I know, and realistically the risk is more that someone steals your car as opposed to someone being able to get in.

What kind of safety system does a Mercedes Benz have?

Your Mercedes-Benz has a range of complex safety systems relying on sensors and safety mechanisms to ensure that your vehicle is working at its optimum performance while ensuring full protection for other road users and passengers.

What kind of door lock does the Mercedes W210 use?

The W210 Mercedes was one of the last cars produced that still used the older, proven vacuum system before finally converting to electrically operated door locks.

This thread is proof that money can buy a Mercedes but not brains or class. Seriously though, no modern car locks itself when you walk away as far as I know, and realistically the risk is more that someone steals your car as opposed to someone being able to get in.

How to change the door lock on a Mercedes Benz?

You’ll see the metal hook connecting the door handle to the release latch. Lift the hook out to release it from the latch. Now look at the backside of the seat adjustment switch. You’ll see the electrical harness going to the switch Pull the harness out of the switch. Also pull the harness going to the lower door light out of the door panel.

Where is the central locking system on a Mercedes?

The locks are vacuum operated. The pump is next to the battery under rear seat. Do you hear the pump starting when you press the remote, or dash button? 1994 E320 Wagon,1999 E320 Wagon,2000 E 320 Wagon, MGB Track/Rally, ,1988 300E ,more…. Resolved his problem.