Can a bad throttle body cause high RPM idle?

High RPM Idle The throttle body controls the engine’s idle to make sure it is always holding a steady RPM. If there is a problem with the throttle body, it may cause the be way too high. A not calibrated throttle body can also cause this.

What are the symptoms of a bad throttle body?

A bad throttle body may cause stalling in the vehicle, misfiring, electrical problems, high or poor idle, and improper throttle stop. Issues such as grime and dirt deposits or vacuum leaks can also cause problems to the throttle body. Below, you will find some further information about throttle body diagnostics.

What to do if your throttle possition sensor has failed?

If you determine the throttle position sensor has failed on your Mercedes-Benz you will need to address this problem right away. In most cases, you will get code P0120 or P012x. Your options are to replace it with a new throttle position sensor. Mercedes-Benz dealerships would be happy to help you or any Indepdement mechanic.

Can a bad throttle body cause strange fuel mixture?

If your car feels like it lost half of its power when accelerating, it can absolutely be caused by a bad throttle body. You already know that a bad throttle body will cause a strange fuel mixture.

How is the throttle connected to the accelerator?

In the old days, there used to be a cable that was connected from the throttle to the accelerator. But now in the technological age, the car’s computer controls when the throttle opens and closes by the feedback it gets about the acceleration of the vehicle.

What does the throttle body do in a Mercedes?

The throttle body is where the throttle valve is mounted and is what control the amount of air that enters the combustion chamber. When there are throttle body malfunctions the wrong amount of air enters into the engine causing problems with air/fuel mixture ratio. Here is a close up picture of a Mercedes throttle body.

What causes a car to jump out of gear when downshifting?

If you can hear the gears clashing only when downshifting, the problem may come from the synchronizer (too much play at the output shaft end). However, a grinding noise may also come from a dragging clutch. Shift linkage problems can cause your transmission to jump out of gear.

Why does my car smoke at the bottom of the hill?

It smokes at the bottom of the hill because as you’’ve cruised down the hill with your foot off the gas, and probably used the engine to help you keep a modest speed, you’ve sucked oil past the worn valve stem seals and into the cylinders. Think of it this way: your engine is like a pump.

What causes a misfire on the throttle body?

Misfires are easiest recognized as small bumps when you are revving the engine. The throttle body controls the engine’s idle to make sure it is always holding a steady RPM. If there is a problem with the throttle body, it may cause the be way too high.

What does it mean when your car has blue smoke coming from the tailpipe?

Blue-gray or gray-white smoke. Blue-gray or gray-white smoke usually means the engine is burning oil. If you have a turbocharged engine, a faulty turbo seal could be causing this, but if you have a more common engine, it’s likely one or more of the following problems:

Can a bad throttle body cause an engine to die?

A not calibrated throttle body can also cause this. You can calibrate the throttle body with most diagnostic scanners. The throttle body can affect the RPM the other way also. It can cause the RPM to be so low at idle so that the engine will die.

What causes a rough idle or a ses?

A Rough Idle or a SES can sometimes be caused by a change in the throttle body position sensor calibration. To correct any accidental changes in throttle body calibration, use these procedures to recalibrate. Note: These procedures are a little tricky to do. You must get the timing just right Use a stop watch to help the precision of your timing.

What are the symptoms of a bad throttle body valve?

A bad throttle body valve can cause a lot of different symptoms in your vehicle. Here is a more detailed list of the most common bad throttle body symptoms. The throttle body has some angle sensors and other sensors installed inside of it.

Why is there high idle after cleaning the throttle body?

The throttle position sensor (TPS) is often located on this body, however, and can be damaged when an untrained person attempts to clean it, resulting in a necessary recalibration after the fact–which can also be inconvenient and requires a trip to the mechanic or dealership. Why is there a high idle?

What happens if the idle valve goes bad?

A normal healthy idle air control valve (IAC) will provide smooth idling in your vehicle. But if the valve goes bad for any reason, the idling will go from smooth to rough. A rough idle will result in intense vibrations forming whenever your vehicle is stopped with the engine running.

What does it mean when your car Idles smooth?

Smooth idling indicates that your engine’s fuel and air are mixing just right. What is rough idling? If your vehicle’s idle is rough, possibly rising and falling, or having difficulty maintaining a steady rate of rotation, you may have a problem that needs fixing.

How does the throttle body work on a car?

The throttle body is a tube that controls the levels of air that enter the engine at any given time. The throttle position sensor combined with the air flow sensor communicate with the computer of the car and tells the car how much fuel is required.

Why does the Check Engine light come on when throttle body is bad?

As soon as the car’s onboard computer detects a problem with the throttle body signal, it will cause the check engine light to illuminate. The check engine light also comes on due to several other reasons, which is why we recommend to visit an auto specialist and have the car scanned for any trouble codes when it pops up on your dashboard.

If your car feels like it lost half of its power when accelerating, it can absolutely be caused by a bad throttle body. You already know that a bad throttle body will cause a strange fuel mixture.

What happens when you replace the throttle body?

If you replace the throttle body, the PCM won’t know and will continue to use the adaptive settings as if the carbon buildup is still in place. If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle.

Is it normal to have a high idle?

I recommend to remove the idle air control valve from the throttle body, clean it, and also clean the throttle plate. That should help with the high idle. Though again, it is normal for cars to experience high idle until it reaches operating temperature.

How long does it take for GM throttle body to relearn?

If you don’t do a relearn procedure, the PCM will “hunt” for a new baseline idle. It will eventually learn it on its own, but it may take over a week of driving, during which time you will experience high and low idle speeds and possibly rough idle. 1) Start the engine and let it idle in park for 3 minutes.

Why does the idle go up after cleaning the throttle body?

The idle is going to be high at first until the computer relearns the idle again. Cleaning the throttle body allowed more air to enter the engine, and the computer is compensating by adding more fuel.

What should I do after replacing my throttle body?

After replacing the throttle body to your engine, if the engine light was on and has a pending code, the code will go away. If the code was a hard permanent code, then the ECM (computer) would need a hard reset. Remove the negative battery cable (-) and keep it off for about 13 minutes, then hook up the battery cable and make sure it is tight.

How to adjust throttle control on a car?

Pull until the cable is taut, then tighten the clamp screw. NOTE: The engine control lever should be against the high idle RPM stop bracket. 6. Move the application throttle control to the slow position, then to fast. Check the engine control to assure it stops against the high idle RPM stop bracket.

What happens after installation of a new throttle body?

After installation of a new throttle body does everything… Q: After installation of a new throttle body does everything reset to normal function on the car? When taking out an old throttle body and putting a new one in does the computer reset itself to normal idling and functions as it was before the the system went down? My car has 80000 miles.

Can a bad throttle position sensor cause idle surging?

Idle surging can be caused due to other issues in the car, but if it happens in conjunction with other throttle position sensor symptoms, the culprit is often the TPS. At idle, the ECM will not get the correct information and the throttle will variate randomly causing idle surges. 3) Check Engine Light

Can a bad throttle position sensor cause stalling?

Similarly, if your engine struggles to idle efficiently, it could also be a result of a damaged throttle position sensor. Stalling, surging, or hesitating while idling all can be caused by this unassuming sensor. The best way to determine if these issues are caused by your throttle position sensor is to go to the source.

How can I Reset my throttle position sensor?

Reprogramming or resetting your sensor can sometimes solve these issues. This step can also be necessary when you install a new sensor. The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.

What does it mean when your engine power is reduced?

In other words: The Engine Power Reduced message is GM’s way of telling you that your car has entered a fail-safe mode. GM’s Reduced Power Mode can inhibit your vehicle’s ability to accelerate. Even if power isn’t reduced immediately, performance may be limited the next time you go to drive the car.

Are there any problems with the GM throttle position sensor?

GM Throttle Position Sensor Problems 1 Function and Location. Throttle position sensors (TPS) are usually located on the large butterfly valve that controls airflow into and out of an engine, called the throttle-body. 2 Inconsistent Idle. 3 Engine Stalling. 4 Erratic Shifting. 5 Maladjusted TPS. …

How does the throttle plate work on a GM car?

A motor and gear reduction set inside the throttle body opens and closes the throttle plate to accomplish your request. Over time, carbon buildup can accumulate around the throttle plate, changing it’s “home” position.

Why does my Chevy 350 Backfire at high RPM?

The 90 degree elbow in the PCV Valve hose at the base of the throttle body to the PCV valve is common to either fall off or have a hole in it. Most of the time the engine will idle at a higher RPM a suction sound can be heard.

Why does a vacuum leak cause rough idle?

Large vacuum leaks can also cause high or rough idle because the throttle body is controlling the idle RPM and when you have a vacuum leak, the engine will suck air from the leak and the throttle body will have problems controlling the idle properly.