How do you reset the anti theft system on a Chevy Cavalier?
Re: HOW TO BYPASS THE ANTI THEFT SYSTEM IN A CHEVY… Turn key on if u see system security light flashing wait 10 min when light turns off turn key off wait 5 sec repeat that same process 2 more times for a total of 30 min on the last one turn key to off wait 5 sec then start worked on a 2000 cavalier.
How do you override anti-theft system?
Turn the key to unlock your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.
What should I do if my Chevy Cavalier wont start?
Here’s my fix, or workaround, turn the key to the point where the dashboard lights up with all the different icons and you can open the automatic windows, but do not start the car. Put the car in Neutral, then turn the key the rest of the way to start the car.
Can you reset the anti theft system on a Cavalier?
Thanks for your advice i appreciate the help. what i did is while the car was running with the stereo on i cut the wires to the anti theft system that come from the ignition. then opened the odometer up and put electricle tape over the light. Yes, cutting the yellow wire will do it. If you disconnect the battery you need to reset it.
When to turn off ACC on Chevy Cavalier?
2ND TURN TO ACC LET IT STAY ON OF 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. TURN IT OFF AND BACK ON TO ACC FOR 11 MINS. THE CAR ON ALL THE WAY JUST TO THE ACC WHEN TRYING TO RESET . AFTER THE 33 MINS IT’S OK TO START.
Is there a Chevy Cavalier ignition switch recall?
There is a recall on 2001 in the serial range, it will be installed for free and if the ignition switch is bad it will be replaced for free. Now was yours done, from the small purple wire from the starter relay there will be a splice and the wire will go up to radiator support to the relay.
How to reset check engine light on Chevy Cavalier?
The way it was described to me for OBDII gm’s is to turn the ignition on, depress the fuel pedal for a full minuite, release and turn the ignition off for a full min, then retry. This is also similiar to how you reset check engine light on gm’s newer cars, except you have to hold the radio button while depressing the pedal and IGN on
How to disable the theft system on a Chevy Cavalier?
Just leave the key in the run position and the “Theft System ” light on the dash will be flashing. Leave the key on for about 10 minutes and the light will stop flashing and go on solid. Then the theft system is disable.
How to disable the PassLock sensor on a Chevrolet Cavalier?
Under the ignition cylinder there is a small connector. Unplug it. This is your passlock sensor. Key on 3 times for 11 minutes each. You may need a battery charger. At the end of the 3rd ignition cycle if the PCM doesnt see the passlock sensor “because you unplugged it” it will disable the passlock.
When does the security light come on on a Chevy Cavalier?
The security light usually comes on with all the the lights and just like all the lights it will go off within 10 seconds as long as no error is seen.