How do you change a clutch slave cylinder?

How to Replace the Clutch Slave Cylinder

Raise and support the front of the vehicle on jack stands.
Remove the slave cylinder by removing the two bolts, one on either end of the slave cylinder.
Install the new slave cylinder.
Fill the clutch master cylinder with brake fluid.

Where is the clutch slave cylinder located?

The slave cylinder is mounted on the transmission or in the bell housing and connects to the clutch wrench, which puts pressure on the clutch release bearing and pressure plate. This causes the clutch to disengage allowing for free gear movement.

Can you drive with a bad slave cylinder?

Yes, usually you have at least a little while between the time you first notice the problem and the time it reaches the point you can’t keep fluid in it at all and the clutch pedal just doesn’t function. This could be a few hours, a few days, or a lot longer.

What happens when your clutch slave cylinder goes out?

If the clutch slave cylinder develops any sort of leak internally or externally it may cause the pedal to feel spongy or mushy. The pedal may also sink all the way to the floor and stay there when depressed, and may not be able to properly disengage the clutch so the transmission can be safely shifted.

Should you replace slave cylinder with clutch?

A failing clutch slave cylinder will likely require replacement, as they may be difficult or impossible to repair. Staying on the lookout for any warning signs of slave cylinder failure or transmission problems will help you be able to treat the problem quickly and effectively with the help of a Porsche specialist.

How to remove a slave cylinder from a clutch?

Open the bleed nipple and pump the pedal until the system is empty of fluid. Remove the plastic tube from the nipple, and dispose of the hydraulic fluid in a safe place – do not empty it down a drain as it is corrosive and poisonous. Loosen the cylinder-pipe union nut and disconnect the release-arm return spring .

How do you replace a clutch master cylinder?

Step 1: Install entire system. Very carefully, install the entire system (clutch master cylinder, hydraulic line, and slave cylinder) down through the engine compartment. Warning: Do not bend the hydraulic line as it will break. Step 2: Install the slave cylinder.

How do you install a clutch slave in a creeper?

Step 8: Make sure that the bleeder screw is tight. Fill up the reservoir with brake fluid to the fill line and install the reservoir cap. Step 1: Grab your creeper and go under the vehicle. Install the clutch slave cylinder to the transmission mount. Finger tighten the bolts and then tighten them at 1/8 turn.

How do you remove a slave cylinder from a Marina Ital?

On some old classics, including a Marina Ital, disconnect the hydraulic pipe and unscrew the slave cylinder (towards the release lever) until the flat on its shoulder faces the clutch housing. Press the pushrod into the cylinder until it clears the release lever, then lift the rod out sideways.

Where is the clutch master and slave cylinder?

The cylinder is connected to the clutch master cylinder located on the firewall next to the brake master cylinder through a hose. When you push the clutch pedal, brake fluid flows from the clutch master cylinder to the slave cylinder, applying the pressure necessary to engage the clutch.

What to do if a clutch slave cylinder leaks?

While using your flashlight, look at the clutch slave cylinder for any damage and leakage. If you do not see any fluid leaking out pull back on the dust boot. Be sure to place a drip pan under the slave cylinder for that brake fluid may leak out. Step 2: Open the hood to your vehicle.