Why is my driver side brake light not working?

Why is my driver side brake light not working?

If your lights don’t illuminate on either side and your brake light switch is good, then the next thing to check is the brake light fuse. Locate your vehicle’s fuse box, which is usually under the hood or on the kick panel inside the passenger compartment. If it has, replace it with a fuse of the same resistance.

How do you check a brake light connector?

Test for power at the socket. Turn on the light switch, then ground the tester to a clean screw on the body of the car. Probe the contacts to see if the tester lights. If the contacts look corroded, scratch the surface, but be careful not to bend or distort them.

How much does it cost to fix brake light wiring?

How much does it cost to rewire brake lights? The average price to replace a brake light wire is between $80 to $100. It is estimated that labor costs are between $45 and $55. The cost of parts is between $35 and $45.

How can you tell if a brake light socket is bad?

The tester should light for two of the three wires (the ground wire won’t light). If it lights for two wires, the wiring is good. Simply replace the socket.

What is the wattage of a brake light bulb?


Turn signal 21 watts (yellow colored glass in most cases)
Brake light 21 watts or 21/5 watts (dual filament bulb, combined position and brake light)
Reverse light 21 watts
Fog light (optional): 21 watts

What are the symptoms of a failed brake light switch?

What Are The Symptoms Of A Faulty Brake Light Switch?

  • Your Brake Lights Don’t Light Up. Your brake lights are supposed to turn on when you push down on the brake pedal, giving a heads up to the driver behind you.
  • Brake Lights Stay On Continuously.
  • Bad Cruise Control.
  • Car Won’t Turn On.
  • ABS Warning Light Comes On.

Where is the fuse on the brake light?

You will get the fuse panel under the dashboard and the PDC under the hood. The brake light switch is also to be found under the dashboard and check if its plunger touches the brake pedal arm. Any problem with the fuse box and light switch will affect the brake lights. In case if the fuse is blown, change it with a new one.

Where are the brake lights and tail lights?

In most European cars, the same bulb does the job of the tail and brake lighting. However, it has double filaments, allowing one set still working while the other set is burnt. You have to find the fuse box or the power distribution center (PDC). You will get the fuse panel under the dashboard and the PDC under the hood.

Why is my passenger side brake light not working?

The brake light (passenger side) went out. I replaced the bulb and the other one while I was at it. But the passenger side brake light still doesn’t work. Even tried switching bulbs to use the one that I knew was working on driver’s side, but still wouldn’t work on passenger side. I see that there’s only one fuse control for both lights.

How long does it take to replace a brake light bulb?

How long does it take to fix a brake light? 1 hour. This is the maximum time for brake light bulb replacement since it is not complicated at all. The process should be around 40 to 60 minutes to complete.