Why is my car turning over but not staying on?
Answer: If the engine cranks but won’t start, check for spark and fuel pressure. If it doesn’t crank at all, check the battery condition. Usually, when the engine warms up and then stops, it is an indication of a problem with an ignition coil, ignition module or even the fuel pump.
What should I do if my Acura MDX won’t start?
3) After verifying #2, go engine block to the small red (?) lead. This is the “signal” lead to the starter, and should light up the test light (or deflect the meter) with the key turned. If these three tests have good results but your starter isn’t engaging, it IS a bad starter.
Where is the starter relay on an Acura MDX?
There is an on-car test for the solenoid but hard to describe without a diagram or picture – you might be able to google it or search the forum. Starter relay is under the dash driver side. You could listen for a click when you turn the key on.
Can a 2003 Acura RL start without a transponder?
Keep in mind, this information was obtain referring to a 2003 ACURAL RL, but may work with other model years. A special, electronically coded key prevents the car from being started, even if a mechanical duplicate of the proper key shape is used. A transponder, built into the key, signals the immobilizer control unit that the key is genuine.
Where is the Immobilizer on an Acura MDX?
Fuse 13 in the passenger’s side under-dash fusebox powers the immobilizer receiver (and a bunch of other stuff you’d probably notice wasn’t working, including the driver’s seat control and navigation if your MDX has it). Fuse #6 in the driver’s side under-dash fusebox seems to be involved, too…
3) After verifying #2, go engine block to the small red (?) lead. This is the “signal” lead to the starter, and should light up the test light (or deflect the meter) with the key turned. If these three tests have good results but your starter isn’t engaging, it IS a bad starter.
What’s the ignition switch on an Acura MDX?
Trans switch that allows to start in Park or Neutral can be tested but again, hard to describe. If you get general power, your ignition switch is probably good. Good luck! The cables are clean and connected properly. Im going to check the start relay in a bit. its raining cats and dogs and its outside.
How do I cancel my Acura transponder key?
1. Dealer (or roadside assistance) contact Acura Tech Line with VIN to obtain key No. and cancel code. 2. Customer advised to have a key cut from a regular key blank and enter the cancel code using the ignition switch and foot-operated parking brake as follows: Example – cancel code is 54345.
What is the cancel code on an Acura?
Customer advised to have a key cut from a regular key blank and enter the cancel code using the ignition switch and foot-operated parking brake as follows: Example – cancel code is 54345. a) Insert the new key in ignition switch and turn to ON (II) position. Indicator light flashes continuously after the initial 2 sec. indication.