Why is ABS light on but no code?
As a general rule, the ABS light can come on with no error codes if the ABS sensor wiring is loose if the tires are worn out or your car needs a wheel alignment, if one of the wheel bearings is bad or if one of the ABS sensors has an intermittent fault.
Can I still drive with VSA light on?
If the VSA System Indicator lights up and stays on, it means there’s a problem with the system itself. In the meantime, it’s perfectly safe to drive your car, but the VSA system won’t be there to protect you in difficult conditions, so it’s a good idea to drive with extra care until the problem is fixed.
How can I read the ABS code on my Acura?
Allow your OBD-2 scanner to connect to the vehicle. This may take a few seconds. Select ACURA from the menu. Next, select the Anti-lock Brake System menu. Using an OBD-II Scanner that can read the ABS, read codes from the ABS module.
Why does my Acura ABS light keep coming on?
Common symptoms that you may notice when there is a problem with the Acura ABS: Wheels may lock and slide when braking. Common problems that trigger the ABS light to stay on: To reset the ABS light on an Acura, you first need to read the codes with an ABS scanner.
What to do if your Acura Dashboard Light does not turn on?
Park your ACURA in a safe area where you can work safely. Locate the diagnostic port under the dashboard. Turn on the ignition. All ACURA dashboard lights should turn on but do not start the engine. If your ACURA has START/STOP button, press it twice without pressing on the brake pedal. Allow your OBD-2 scanner to connect to the vehicle.
Is there a VSA system warning on an Acura MDX?
2008 Acura MDX , with VSA system warning, SH-AWD warning, ABS system warning, Trailer Stability warning”: bought this vehicle last weekend. has 26k miles. tonight all the warnings listed above came on. After turning the ignition off and restarting the vehicle the codes go away. But they return 5-10 minutes later Submitted:8 years ago.
Allow your OBD-2 scanner to connect to the vehicle. This may take a few seconds. Select ACURA from the menu. Next, select the Anti-lock Brake System menu. Using an OBD-II Scanner that can read the ABS, read codes from the ABS module.
What should I do about my 2008 Acura MDX?
The emission 2008 acura mdx 118000 miles all maintenance done. The emission problem light and SH AWD warning lights came on tonight. What should I do? … read more
Park your ACURA in a safe area where you can work safely. Locate the diagnostic port under the dashboard. Turn on the ignition. All ACURA dashboard lights should turn on but do not start the engine. If your ACURA has START/STOP button, press it twice without pressing on the brake pedal. Allow your OBD-2 scanner to connect to the vehicle.