Why does my power inverter keep blowing fuse?

Why does my power inverter keep blowing fuse?

You need at least that heavy wire and just because it have that type of plug in doesnt mean it was designed to plug to lighter,,, it may go to power point which may be heavier. Visit sberry27’s homepage! I see from post in electric that there is a 30 a fuse on the unit.

Where is the fuse box located on an Acura MDX?

The rear fuse box is located at the left side of cargo area. The primary under-hood fuse box is located next to the battery. The secondary under-hood fuse box is on the passenger’s side. The sub fuse box is on the passenger’s side (under-hood).

How big of a fuse do I need for an inverter?

Use 14 or 12 AWG wire & a 30 A fuse. Let us know what happens. I think you might need to run a bigger wire and a bigger fuse than a cig lighter. It was probably designed to have an auxilary power point installed,,, in the nature of a 10 wire and a 30 A fuse.

How do you check a blown fuse on an Acura MDX?

Replace any blown fuses, and check if the device works. Turn the ignition switch to the LOCK (0) position. Make sure the headlights and all other accessories are off. Remove the cover from the fuse box. Check each of the large fuses in the primary under-hood fuse box by looking through the top at the wire inside.

You need at least that heavy wire and just because it have that type of plug in doesnt mean it was designed to plug to lighter,,, it may go to power point which may be heavier. Visit sberry27’s homepage! I see from post in electric that there is a 30 a fuse on the unit.

Why does my AC clutch fuse keep blowing?

If it fails then you have a wiring issue to the compressor. If it does not, then the ac compressor clutch is causing the high current draw and the compressor needs to be replaced. helpful?

What should I do if my Clutch fuse keeps failing?

If the fuse keeps failing, then there is too much current draw on the circuit. The first thing I would do is to remove the connector from the AC compressor and leave it disconnected. Turn the key on, turn the AC on and see if the fuse still fails. leave it sit for about fifteen to twenty minutes.