Why does my Hyundai Santa Fe have vibration?
2011 Hyundai Santa Fe. Consumer writes in regards to vehicle vibration issues. The dealer determined the rear coupler was broken. It was replaced. However, the vibration continued. The consumer returned to the dealer, where they found the front axle was broken and it was replaced.
Are there any problems with the Hyundai Santa Fe?
See all problems of the 2017 Hyundai Santa Fe . The contact owns a 2010 Hyundai Santa Fe. While driving 25 mph, the front passenger side of the vehicle vibrated. The vehicle was taken to an independent mechanic where it was diagnosed that the intermediate shaft needed to be replaced. The part was not repaired.
Why does my 2004 Hyundai Santa Fe Shudder?
See all problems of the 2004 Hyundai Santa Fe . Car shudders 3 times when go to drive after car has been off. Definite transmission problems, also, transmission does not engage correctly when trying to pass at low or high speeds. Only has 7500 miles, dealer can not find anything wrong.
How much does it cost to have a Hyundai Santa Fe engine inspected?
Hyundai Santa Fe Engine is shaking, pulsating or vibrating Inspection at your home or office. Hyundai Santa Fe Engine is shaking, pulsating or vibrating Inspection costs $85 on average. Following is a breakdown of the labor and parts estimates. Fast and easy service at your home or office.
Why does my Hyundai Santa Fe shudder during acceleration?
Few weeks after the purchase of my Santa Fe, the car began to shudder during acceleration. I have been to the dealership twice for this problem. The first time they could not duplicate the problem. The second time they duplicated but they could not figure out what was wrong before the three day rental car rule.
What’s the VIN on a 2010 Hyundai Santa Fe?
The VIN was not included in NHTSA campaign number: 11v261000 (power train). The failure mileage was 77,883. See all problems of the 2010 Hyundai Santa Fe . 2011 Hyundai Santa Fe. Consumer writes in regards to vehicle vibration issues. The dealer determined the rear coupler was broken. It was replaced. However, the vibration continued.
2011 Hyundai Santa Fe. Consumer writes in regards to vehicle vibration issues. The dealer determined the rear coupler was broken. It was replaced. However, the vibration continued. The consumer returned to the dealer, where they found the front axle was broken and it was replaced.
See all problems of the 2017 Hyundai Santa Fe . The contact owns a 2010 Hyundai Santa Fe. While driving 25 mph, the front passenger side of the vehicle vibrated. The vehicle was taken to an independent mechanic where it was diagnosed that the intermediate shaft needed to be replaced. The part was not repaired.
How to adjust the front of a Hyundai Santa Fe?
3. Adjust the toe by screwing or unscrewing the tie rod. Toe adjustment should be made by turning the right and left tie rods by the same amount. 4. When completing the toe adjustment, install the bellows clip and tighten the tie rod end lock nut to specified torque. When the wheel tilts out at the top, then the camber is positive (+).
Can you feel the vibration in the steering wheel?
Less than a week after I got the car, I detected vibrations in the seat, in the floorboard and when I rest my elbow on the arm rest while driving 55 mph or over. Over 70 mph, I can feel the same vibrations (a little less intense) in the steering wheel.