Why does my high beam work but not my low beam?
Headlight Fuse or Relay These are designed to ‘blow’ and break the circuit if too much power comes through them. Most headlight systems are also designed with a relay that switches the power between low beam and high beam headlights. If this relay goes bad, it could allow power to the high beams, but not the low beams.
What would cause my low beam headlights not to work?
Most total headlight failures are caused by a bad component like a fuse, relay, or module. High beam headlights don’t work or low beams don’t work. The cause: A burned out bulb, or a problem with the high beam switch or relay. The fix: Replace the bulb, switch, or relay.
How do you check if a fuse is blown?
Remove the fuse from its holder. In some cases you may need a small screwdriver to unscrew the fuse holder cap. Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
How to troubleshoot an Acura TL headlight problem?
If the headlights are still not working, there may be an issue with the fuse. Locate the primary under-hood fuse box on the driver’s side. Remove the cover and locate the fuse numbered “3-2.” If the metal piece inside the fuse is broken, it will need to be replaced. Use the fuse puller to remove the fuse. Replace it with an identical 40A fuse.
Why are my headlights not working in high beam?
If just one bulb fails to work in either high beam mode or low beam mode, it may be the bulb. Most headlight failures that are limited to just high or low beams are related to a relay or the high beam control switch.
What should I do if my headlight light is not working?
The best way to do this is to turn the headlight switch on, connect the negative lead on your meter to a known good ground, and touch the positive lead to each headlight connector terminal. One of the terminals should show battery voltage, and the other two should show nothing if the problem is burned out bulbs.
Do you need to replace both high and low beams?
Some vehicles use a single bulb for both high and low beams while others do not. If the high beam on the same side is also out, it may be one bulb. You do not need to purchase specific bulbs for each side, but identifying which is the blown out bulb will help you to replace it without having to start the vehicle again.
Is it possible to fix a bad low beam headlight?
Fortunately, fixing a bad low beam is a straight forward process in the majority of vehicles that can be done by most people without just a few hand tools. If replacing your headlight bulb does not work, there may be an electrical issue in your vehicle that should be addressed by a professional. Identify a blown out bulb.
What to do when your low beam light goes out?
Disconnect the battery. Be sure you remember which side of the car has a blown out low beam bulb before disconnecting the battery. To disconnect it, use a hand or socket wrench of the appropriate size to loosen the nut holding the ground cable onto the negative terminal of the battery.
Some vehicles use a single bulb for both high and low beams while others do not. If the high beam on the same side is also out, it may be one bulb. You do not need to purchase specific bulbs for each side, but identifying which is the blown out bulb will help you to replace it without having to start the vehicle again.
What happens if a headlight comes loose while driving?
If the wires come loose while you are driving, the headlight will stop working. The headlight bulb and assembly should now be connected to the car once again. Be careful not to yank on the assembly with it connected, as you may rip a wire out of the harness.