Why did my car radio suddenly stop working?

Why did my car radio suddenly stop working?

Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. If the radio itself will not turn on, chances are good that there’s one or more blown fuses causing the problem. This can also cause fuses to blow in rapid succession (you replace a fuse and it blows again shortly after).

What is a 10 4 police code?

10-4 is an affirmative signal: it means “OK.” The ten-codes are credited to Illinois State Police Communications Director Charles Hopper who created them between 1937–40 for use in radio communications among cops. The use of the number 10 before all of the codes was another workaround.

How do you reset the battery on a Honda Accord?

How to Reset My Honda Accord Anti-Theft After Changing a Battery

  1. Insert the ignition key in the Accord’s driver-side door lock.
  2. Turn the key to the unlock position.
  3. Turn the key to the lock position.
  4. Turn the key back to the unlock position. The alarm should now be disabled.

What does code error e mean on a Honda Civic?

error means that you have incorrectly entered the radio code more the 3 times and it has locked you out.

What to do if your s + battery goes bad?

If the voltage on the battery gets too low…you run the risk of requiring the clear/set roms to clear the eeprom’s ram and re-enable bill validators, progressive jackpots, ticket printers, and other accessories. This procedure should be the same in all S+ machines regardless of game title currently installed.

What happens when you replace the battery in a car?

Replacing the battery on some vehicles may simply be plug-and-play — just remove the old one, put in the new one, and you’re on your way. But some cars can react differently when you disconnect and then reconnect the primary source of power.

What to do if your car stalls after a battery replacement?

Even if your car doesn’t stall after a battery replacement, it may lose other settings. But there’s a simple way to prevent all of these problems. A “memory saver” device, when used correctly, will retain the computer memory, clock, radio presets, power seat position and many other settings.

What to do if FOB does not recognize Battery?

A dealer can reset it for you, but I’m sure they are pretty proud of that service. Do not change the fob battery standing next to the bike, walk away from it far enough so that the bike can’t “see” the fob. You have to let the system reset itself and then walk up to the bike.