Where is the thermostat on a 2002 Dodge Caravan?

Locate the thermostat by following the upper radiator hose from the radiator to the housing on the engine. Place a drain pan under the radiator valve. Remove the radiator cap and open the radiator drain valve to remove at least half a gallon of coolant.

Where is the thermostat on a 2003 Chrysler Town and Country?

The thermostat is just below the ignition coil on the outlet of the upper rad hose. Do the following when the engine is cold. Drain the the cooling system into a suitable sized container. 4 or 5 liters will be enough to get the level lower than the thermostat housing.

Where is the thermostat located on a Chrysler 3.3?

Trace the upper radiator hose toward the engine until you reach the metal connection point between it and the engine, this is called the thermostat housing. Loosen the hose clamp holding the upper radiator hose to the thermostat housing, using a ratchet and socket, and pull the hose from the housing.

How do you change the thermostat on a Chrysler Town and Country?

Slide the drain pan under the driver side of the radiator and open the petcock. Once the coolant reservoir bottle is empty, remove the radiator cap and allow the coolant to drain. Close the petcock and remove the drain pan. Loosen the upper radiator hose clamp at the thermostat housing and remove the hose from the housing.

What causes bleed hole in Plymouth Voyager thermostat?

If you have a V-6 engine, the 3.0L Mitsubishi engine in particular, there is a very small bleed hole in the thermostat. The problem occurs if you have an aftermarket thermostat installed that doesn’t have that bleed hole.

What should I use to replace the thermostat on my Chrysler Sequoia?

Replace the thermostat with Mopar part No. 5184570AH or equivalent. If you use new coolant, Chrysler recommends using distilled or deionized water when mixing the 50-percent solution of coolant and water. Chrysler does not recommend using well or tap water. Allow the engine to cool completely before opening the cooling system.

Trace the upper radiator hose toward the engine until you reach the metal connection point between it and the engine, this is called the thermostat housing. Loosen the hose clamp holding the upper radiator hose to the thermostat housing, using a ratchet and socket, and pull the hose from the housing.

If you have a V-6 engine, the 3.0L Mitsubishi engine in particular, there is a very small bleed hole in the thermostat. The problem occurs if you have an aftermarket thermostat installed that doesn’t have that bleed hole.

How to replace the thermostat on a Dodge Caravan?

(Playback ID: nKWYh85YUg-PlTLt) An error occurred while retrieving sharing information. Please try again later.