Where is the intake air temp sensor located?
The intake air temperature sensor (IAT) is located in the air pipe at the back of the main entrance. The intake air temperature sensor (IAT) is located at the bottom of the intake collector, directly behind the acceleration valve box.
How do I clean my intake air temperature sensor?
To clean the intake air temp sensor: remove the duct from the throttle body and spray the sensor. Two or three shots will remove almost any oil-based contamination from it. The stuff dries fast, almost instantly.
How do I fix code P0113?
Because a P0113 code is most frequently caused by either a dysfunctional circuit or a failed IAT sensor, the most common repair is simply replacing the faulty component. You can also try cleaning the IAT sensor tip and replacing the grounds.
Where is the intake air temperature sensor located?
Intake Air Temperature Sensor located in the intake air duct from the air filter box or in the intake manifold to the engine. It’s job is to report the temperature of the outside air being drawn into the engine. The intake air temperature sensor reports its findings directly to the powertrain control module or engine control module.
Where are the components located in a Kia Sportage?
Component Location Components 1. Heater Case (LH)2. Heater Case (RH)3. Heater Lower Case4. Separator5. Shower Duct6. Heater Core7. Evaporator Core8. Evaporator Sensor9. Vent Door10. Vent Door11. …
Where is the IAT sensor on an air conditioner?
The IAT sensor is usually located in the air intake boot, but it may also be located in the air cleaner housing or intake manifold. Step 2: Disconnect the negative battery cable.
How can I test my air temperature sensor?
You can test an intake air temperature sensor using a digital Ohm Meter set on the DC volts scale. Turn the IGN switch to the ON position and backprobe the return wire to see the voltage being reported to the PCM/ECM. You can also test the sensor’s resistance, but that’s not as accurate as reading the actual return voltage.
How to test and replace intake air temperature sensor?
(No jewelry, baggy clothes, etc.) You can also use a hair dryer to test the sensor. This was performed on a 1997 Nissan Maxima. Check with your vehicle’s repair manual for testing parameters. The intake air temperature sensor detects intake air temperature and transmits a signal to the ECM.
Component Location Components 1. Heater Case (LH)2. Heater Case (RH)3. Heater Lower Case4. Separator5. Shower Duct6. Heater Core7. Evaporator Core8. Evaporator Sensor9. Vent Door10. Vent Door11.
When did Kia Sportage start using OBD’s?
Data Link Connector (DLC) [16-Pin] OBD-II review 1. Overview The California Air Resources Board (CARB) began regulation of On Board Diagnostics (OBD) for vehicles sold in California beginning with the 1988 model year. The first
How to remove the console from a Kia Sportage?
Removal 1. Remove the knob. Remove the floor console upper cover (A) using the appropriate tool. (Refer to the BD group – “Console”) 2. Loosen screws (2EA) and remove the floor console tray (