Where is the crank sensor on a Vauxhall Vivaro?

And does the pedal trick work for the fault codes cheers Standing at the front of the van (with the bonnet open ) look to the right between the radiator and the gearbox, and it’s on the bell housing, No4 in the diagram, and No! Thanks for the replies, fitted a new 1 but still not starting.

What are the codes for a Vauxhall Vivaro?

The garage i use have drawn a blank said it could be turbo but as the van runs ok and turbo is working around town they don’t think this is the problem has anyone got any info that could help me the codes are po100 (B) mass air flow high input.

What causes a Vauxhall Vivaro to not start?

A leak back check on the injectors may reveal a worn out injector leaking back too much diesel, causing the entire rail pressure to drop and a non start as a result. Pedal trick doesn’t work on these vans. Whats the symptoms . Turning over ?

When was the crankshaft sensor replaced in Vauxhall?

June 2002 – EM light on again very regularly. Occasionally while driving, the rev counter would swing up to 7000 rpm and back down, up and down erratically, sometimes settle down sometimes causing the engine to cut out. July 2002 – EM light on every time engine started. Crankshaft sensor replaced, no effect on engine, fault still exists.

And does the pedal trick work for the fault codes cheers Standing at the front of the van (with the bonnet open ) look to the right between the radiator and the gearbox, and it’s on the bell housing, No4 in the diagram, and No! Thanks for the replies, fitted a new 1 but still not starting.

A leak back check on the injectors may reveal a worn out injector leaking back too much diesel, causing the entire rail pressure to drop and a non start as a result. Pedal trick doesn’t work on these vans. Whats the symptoms . Turning over ?

June 2002 – EM light on again very regularly. Occasionally while driving, the rev counter would swing up to 7000 rpm and back down, up and down erratically, sometimes settle down sometimes causing the engine to cut out. July 2002 – EM light on every time engine started. Crankshaft sensor replaced, no effect on engine, fault still exists.

Where are the sensor wires in a Vauxhall?

Wiring loom tested O.K. no short cct’s no high resistances. Removed sensor wires form main wiring loom within engine bay, to prevent interference.