Where is the brake light switch on a 1998 Silverado?
The brake light switch is on the arm from the brake pedal to the brake booster (under the hood). It is held in place by a snap clip that is nearly impossible to get off, so don’t. Buy your switch and a new snap clip and then take a large screwdriver and shove it between the top of brake petal and the switch.
Why are my brake lights not working on my 1997 Chevy?
Pull the plastic cap off the fuse chassis and you’ll see a square relay fuse switch and replace it for the brakes. It’s only $13 bucks and is the predominant issue with 1997 Chevy Trucks and the brakes not working especially if you reverse and blinker lights do work. Was this answer helpful? Its the taillight circuit board or a broken wire.
Where are the brake lights on a Chevy C / K 1500?
There is a break light relay I think down under drivers side, or under the hood in the fuse box. Blinkers are working so the circuit is good. 32 people found this helpful. Thanks Rowefast, it was the brake light relay.
Are there any brake lights on my plow truck?
89 K1500 no brake lights, no hazard lights? Yesterday I lost the brake lights and hazard lights dont come on when hazard button pushed in to my ole plow truck. No clicking sounds from hazard like it used to. The turn signals still work and the both rear running lights still work. Where do I start looking? Thanks. Have you checked all the fuses?
Pull the plastic cap off the fuse chassis and you’ll see a square relay fuse switch and replace it for the brakes. It’s only $13 bucks and is the predominant issue with 1997 Chevy Trucks and the brakes not working especially if you reverse and blinker lights do work. Was this answer helpful? Its the taillight circuit board or a broken wire.
Where do the brake lights go in a car?
The way those taillights work theres a white wire under dash on the column that white wire is for brake light. So the way the brake lights work they go through a relay and through blinker switch.
Where are the brake lights on a C / K 1500?
There is a switch. I think on most C/K 1500/2500 it is on the brake pedal arm or the arm hits it. It is $5-$10; you might take ALL your truck data to the auto parts store, buy a new switch, then look for the same thing around the brake arm or under the hood. There’s a fuse. Find the fusebox and look for “brake”. The Owner’s Manual may have clues.
How do you know if your Chevy has a brake problem?
You will find the booster between the master cylinder and the firewall in your engine compartment. A check valve that is faulty can also let vacuum bleed out. You can diagnose this by starting your Chevy in order to build vacuum, and then turning it off for four or five minutes. Then you should try the brakes.