Where is the back up light switch on a Dodge Ram?

Location of backup light switch for 98 dodge ram 4×4 5 speed manual p/u. back up light does not come on when you put in – Answered by a verified Dodge Mechanic We use cookies to give you the best possible experience on our website.

Where is the backup light switch on a car?

Remove the box after removing the bolts securing the box to the vehicle. Step 4: Attempt to locate the backup light switch on the top side of the transmission. On some vehicles, the switch may be visible at this point. If you have a transverse (sideways) mounted engine, you should be looking at the top side of your transmission.

Where is the transmission switch on a Dodge Ram?

Replacing this switch is simple and should cost less than $30. The switch is located on the driver’s side of the transmission up near the front linkage. It is screwed into the tranny, so when removed, you will have some fluid loss. Before you remove it, get the replacement ready with some Teflon tape wrapped around the threads.

Where is the switch plunger on a Dodge Ram?

The switch plunger is operated by the fifth-reverse shift rail. The switch can be replaced with the transmission in, or out of the vehicle. A gasket must used with the switch. Apply sealer to the switch threads before installation. Ron Z., – Dodge Tech – Category: Dodge Satisfied Customers:22,211 Experience: 18+yrs experience.

Where is the backup light switch located on a truck?

On many trucks or rear wheel drive vehicles, the transmission is normally located farther back, and only accessible from under the vehicle. Step 1: Disconnect the electrical connector. Squeeze the tab on one side of the connector and disconnect the switch from the wiring harness.

Where is the backup light switch on a Honda Accord?

Find the backup light switch connector high up on the passenger side of the transmission, just behind the transmission case seam. The connector is on the wiring harness that also branches out to the oxygen sensors. Disconnect the connector and remove the mounting bolt for the switch.

Where is the reverse light switch on a car?

If the reverse light switch is attached to the transmission, you’ll have to access it underneath the vehicle. Either way, you’ll have to unscrew the old back-up light switch, disconnect the wires, connect the new one and screw it into place.

Can a backup light switch be replaced in reverse?

Average rating from 12 customers who received a Reverse Light Bulb Replacement. Replacing a backup light switch is fairly straightforward if you know what the switch looks like and where to locate it on your vehicle. A backup light switch screws into the transmission and is triggered when you shift the vehicle into reverse.

Where is the backup light switch on a Dodge Ram 1500?

Park your Ram 1500 on level ground. Find the electrical ground for the backup light switch circuit. The ground is connector No. G107 in the engine compartment, high on the passenger-side fender, just forward of the firewall. Make sure the ground bolt is tight and there’s no corrosion between the contact surfaces. Chock the rear wheels.

Are there any backup lights on my truck?

The reason I know how this one works is when the truck was completed, it had no backup lights, no motorized pedals, and no 4wd lights on the dash. There is no relay anywhere for the backup lights, Until I added one. The switching is done electronically, and that is always less reliable than a simple mechanical switch.