Where is my water pump located?

Your car’s water pump is the key to making the entire system work. It is an impeller pump and is usually buried under the timing belt cover on the side of the engine. The pump is operated by the engine’s drive belt – as the belt turns, the pump turns.

Is it hard to change a water pump?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

How do I change my water pump?

Loosen the bolts and remove the old water pump. Remove the old seal/gasket or old sealant remains and make sure the mounting surface is clean. Before installing the new water pump, inspect the other cooling system service parts: coolant hoses, thermostat and pressure cap(s). Install the new water pump.

How can I tell if my water pump is bad?

5 Symptoms of a Failing Water Pump

1. Coolant Leaking. One of the first signs of a potentially faulty water pump is a puddle of coolant on the ground where you’ve parked your car.
2. Rust or Deposit Build-Up.
3. Noise.
4. Overheating.
5. Steam.

How do you replace a water pump in a car?

Allow the engine to cool completely and disconnect the battery. Put a drain pan under the engine and drain the entire cooling system. To work on the water pump, you’ll need to remove the drive belts and perhaps the engine pulley. Remove any parts that block your access to the water pump (there may be several) and detach any hoses from the pump.

Where is the water pump on a Chevy engine?

The water pump is located just above – and to the right – of the crankshaft pulley. It is above – and to the left – of the air conditioner compressor. Step 2: Remove all the items blocking access to the water pump.

How to replace the water pump in a Dodge Caravan?

Dodge also made the serpentine belt removal (required to replace the water pump) a problem for the home mechanic on these later-model caravans – this video shows a home-mechanic’s trick to release the belt tension without any special tools. Best of luck! Loading…

How can I tell when my water pump needs to be replaced?

Find the round part at the front of your water pump that the belt is around. Attempt to rock the pulley back and forth. If it seems to be loose, it may be time to replace it, because the bearing is going bad.

How do you replace a water pump in a Dodge Ram?

Remove the four bolts that hold the A/C compressor to the bracket, and then remove the accessory bracket that mounts to the intake manifold. This entire assembly needs to come out. Take care when pulling the bolts. This is a pretty heavy piece of equipment that is coming off. Don’t let it drop. Figure 7.

What to do if your car water pump needs replacing?

Let your car sit overnight, parked in a garage with a clean concrete floor. If it’s not possible to park it inside on a clean concrete surface, place a piece of light-colored cardboard underneath your car directly under the motor.

How long does it take to replace water pump in Dodge Caravan?

Dodge didn’t do us (the home mechanic) any favors by placing the water pump where they did, but it can be done in a few hours with normal hand tools. We show you how in just over 5 minutes.

How does a water pump work in a car?

In the majority of today’s cars, a water pump is a mechanical device rotated by a drive belt. The drive belt itself is driven by the crankshaft pulley of the engine. In some cars, a water pump is driven by a timing belt or timing chain.